battery
411 results for "battery"
project1 led
A simple single-sided LED torch with CR2032 battery holder,a switch and current-limiting resistor.
tiny board
A small, battery-powered carrier board for the Raspberry Pi CM4 (and other compatible CM4 replacments).
KiCAD Custom DRC Rules for PCBWay
A power management PCB designed to charge a lithium-ion battery and power a low-power Arduino application
Solar PCB KiCad
A power management PCB designed to charge a lithium-ion battery and power a low-power Arduino application
2023 PiezoPreamp
Piezo preamplifier v2 with Baxandall tone control and battery indicator. KiCAD v7 project.
stm32 bluet pill
This project is a 1.8V STM32WB55 Bluetooth Module with battery charging. The purpose of this project is to provide a development platform for mobile wearable devices.
rbc circuits
circuit incorporates chip on board + on-board 12V regulator + battery level detection + reduced half h-bridge ICs for Kiwi drive + current sense filter
LCMscope
Limitless Common Mode Scope. Battery powered probe with fast ADC with FPGA and UART connection. Data acquisition takes place when the trigger signal is high, later data is sent via UART to the computer. Purpouse of this device is to make precise measurements for high common mode signals.
Project63 BMS DaughterBoard
Distributed BMS designed for FSAE around the STM32 microcontroller and BQ79616/BQ79614/BQ79612 precision battery monitor, balancer and integrated protector.
FSAE BMS
Distributed BMS designed for FSAE around the STM32 microcontroller and BQ79616/BQ79614/BQ79612 precision battery monitor, balancer and integrated protector.
BMS Project
Repository for Arduino & ESP source code for a initial version of a battery management system. The BMs meaures individual cell voltages, as well as current and temperatures. SOC and SOH algorithms will be implemented additionally.
Cell holder board
Repository for Arduino & ESP source code for a initial version of a battery management system. The BMs meaures individual cell voltages, as well as current and temperatures. SOC and SOH algorithms will be implemented additionally.
test kicad
Repository for Arduino & ESP source code for a initial version of a battery management system. The BMs meaures individual cell voltages, as well as current and temperatures. SOC and SOH algorithms will be implemented additionally.
