battery_custom
242 results for "battery_custom"
default
800mV-5.5Vin <5W high efficiency MPPT battery charger with autonomous perturb and observe set point adjustment
spv1040
800mV-5.5Vin <5W high efficiency MPPT battery charger with autonomous perturb and observe set point adjustment
spv1040t
800mV-5.5Vin <5W high efficiency MPPT battery charger with autonomous perturb and observe set point adjustment
docking connector
Multi-Agent Mission Concept for Battery Optimized Onsite Swapping Technology (BOOST)
tiny board
A small, battery-powered carrier board for the Raspberry Pi CM4 (and other compatible CM4 replacments).
Solar PCB KiCad
A power management PCB designed to charge a lithium-ion battery and power a low-power Arduino application
2023 PiezoPreamp
Piezo preamplifier v2 with Baxandall tone control and battery indicator. KiCAD v7 project.
stm32 bluet pill
This project is a 1.8V STM32WB55 Bluetooth Module with battery charging. The purpose of this project is to provide a development platform for mobile wearable devices.
rbc circuits
circuit incorporates chip on board + on-board 12V regulator + battery level detection + reduced half h-bridge ICs for Kiwi drive + current sense filter
LCMscope
Limitless Common Mode Scope. Battery powered probe with fast ADC with FPGA and UART connection. Data acquisition takes place when the trigger signal is high, later data is sent via UART to the computer. Purpouse of this device is to make precise measurements for high common mode signals.
