usb_a_stacked
836 results for "usb_a_stacked"
ESP32 C3 Mini
4-layer ESP32-C3 WROOM development board with USB-C, ESD protection, LDO regulation and differential pair routing — designed in KiCad
dcpower
DC Power Unit for Breadboard based on ESP32-S3 microcontroller and AP33772S USB Power Delivery (PD) Sink Controller.
haasoscope pro adc fpga board
Affordable 2 GHz 3.2 GS/s 12 bit open-source open-hardware expandable USB real-time oscilloscope
drandyhaas
462
AudioInterface
An hardware audio interface featuring an ouput selector and an amplifier powered by usb C
STM32F042G6Ux
Cheap and simple evaluation board for the STM32F042G6Ux microcontroller, with direct USB connectivity.
MOTOR RF HAT
RP2040-based AZ/EL rotator controller for SatNOGS-compatible satellite ground stations. Custom PCB, PID motor control, EasyComm/hamlib protocol over USB.
RF HAT
RP2040-based AZ/EL rotator controller for SatNOGS-compatible satellite ground stations. Custom PCB, PID motor control, EasyComm/hamlib protocol over USB.
motorPCB
RP2040-based AZ/EL rotator controller for SatNOGS-compatible satellite ground stations. Custom PCB, PID motor control, EasyComm/hamlib protocol over USB.
DAC ADC PWM IO
STM32 microcontroller with lots of periferials such as ADC, differential ADC, Input Capture, PWM, USB, Encoder, DAC, Digital Input, RTC, CAN-bus + Alarm etc.
esp32 hw130 adapter
ESP32 DVD pen plotter with HW-130 L293D shield: custom firmware, socket-plug wiring, USB/Bluetooth G-code
Interrupter v1.2
Custom 4-layer interrupter control board for DRSSTC systems. STM32F405-based, fiber-optically isolated outputs, hardware E-brake safety chain, and controlled-impedance routing (90Ω USB, 50Ω FSMC/SDIO). Designed in KiCad 9.0.
machxo2 design kicad
Development/eval board for Lattice MachX02 FPGA, TPS543320 & TPSM8282 DC-DC converters, and FTDI2232H USB-JTAG chip.
kratos pack
Battery case with electronics for charging and protection of battery cells. Composes of 2s li-ion 3,7V battery cells. Includes undervoltage, overvoltage and overcurrent protection. As well as reverse voltage protection. Is charged from USB type-C connector. Support statistics over USB and have battery voltage indication via LEDs.
RingOne
3D air mouse based on STM32 - Can be used for controlling CADs and every other manipulation in 3D space. Is based around STM32L452, IMU LSM6DSL (gyroscope and accelerometer) and Bluetooth low power module RN4871. Also contains battery management system for charging internal battery and also powering itself from this li-po battery (around 40 mah). Battery can be recharged via USB type C which can be also used for streaming data from accelerometer.
usb power board
This repo includes all software necessary to operate the Test Rover Platform that is being designed and developed in the 502 project.
