picard
weiiwang01
Components (59)
| Reference | Value | Description |
|---|---|---|
| Q1-Q5 | DMN32D2LFB4 | |
| U1 | ADM3101EACPZ | ±15 kV ESD Protected, 3.3 V Single- Channel RS-232 Line Driver/Receiver |
| U2 | 74HC123PW | Dual retriggerable monostable multivibrator |
| U3,U4,U18-U21 | TPD4EUSB30 | |
| U5 | AP2191W | Current limited power switch, single channel, SOT-23-5 |
| U6 | TPS82130 | |
| U7 | TPS62180 | |
| U8,U13-U15 | AP21510 | |
| U9,U10 | TVS2200DRV | Flat-Clamp Surge Protection Device. 22Vrwm, WSON-6 |
| U11,U12,U16,U17 | TPS259470 | 2.7-V–23-V, 5.5-A, 28-mΩ True Reverse Current Blocking eFuse with Input Reverse Polarity Protection |
| U22,U23 | TPD6S300A | USB Type-C Port Protector: Short-to-VBUS Overvoltage and IEC ESD Protection, WQFN-20 |
| U24,U25 | FUSB340TMX | |
| U26-U28 | TS3USB221 | |
| U29 | TLV70433 | 24-V, 150-mA, 3.2-μA Quiescent Current, Low-Dropout Linear Regulator |
| U30 | STM32G071CBUx | STMicroelectronics Arm Cortex-M0+ MCU, 128KB flash, 36KB RAM, 64 MHz, 1.7-3.6V, 44 GPIO, UFQFPN48 |
| BT1 | CR1220 Battery | Single-cell battery |
| C1-C5,C17,C21,C27-C41,C43,C46,C51 | 100n | |
| C6,C7,C25,C26,C44,C47,L1,L2 | 1u | Unpolarized capacitor |
| C8,C18,C22 | 10u | |
| C9,C10,C13,C14 | 22u | |
| C11,C12 | 47u | |
| C15 | 22n | |
| C16 | 430pF | |
| C19,C20,C23,C24 | 2.2n | Unpolarized capacitor |
| C42 | 4.7u | Unpolarized capacitor |
| C45,C48 | 18pf | Unpolarized capacitor |
| C49,C50 | 4.7u 50V | Unpolarized capacitor |
| ComputeModule1 | ComputeModule4-CM4 | RaspberryPi Compute module 5 |
| D1-D3,D8,D9 | 1N5819WS | |
| D4,D7 | Zener 20V | Zener diode |
| D5,D6,D13 | D | Diode |
| D10-D12 | WS2812B | RGB LED with integrated controller |
| H1,H2 | MountingHole | |
| J1 | RS232 | |
| J2 | Ethernet | |
| J3 | Micro_SD_Card_Det2 | |
| J4 | Bus_M.2_Socket_M | |
| J5,J6 | USB_C_Receptacle | |
| J7 | Conn_02x05_Odd_Even | Generic connector, double row, 02x05, odd/even pin numbering scheme (row 1 odd numbers, row 2 even numbers), script generated (kicad-library-utils/schlib/autogen/connector/) |
| R1,R2,R5,R6 | 470 | |
| R3,R4,R12 | 100k 1% | |
| R7,R8,R14,R25,R26,R39-R41 | 12k | |
| R9,R34,R35,R37,R38 | 3.3k | Resistor |
| R10 | 787k | |
| R11 | 309k | |
| R13 | 150k 1% | |
| R15,R16 | 220k 1% | Resistor |
| R17,R18 | 59k | Resistor |
| R19,R20 | 28.7k | Resistor |
| R21-R24 | 953 | Resistor |
| R27,R28 | 120k | Resistor |
| R29,R30 | 4.7k 0.25W | Resistor |
| R31,R32 | 10k | Resistor |
| R33,R36 | 5.1k | Resistor |
| SW1 | SW_Push | Push button switch, generic, two pins |
| SW2 | SW_DIP_x04 | 4x DIP Switch, Single Pole Single Throw (SPST) switch, small symbol |
| TP1-TP8 | TestPoint | test point |
| TR1 | H2456G | |
| Y1 | 32.768kHz |