Loading design…
sparkfun
A small board that adds a display, navigation, logging, and battery management.
| Reference | Value | Description |
|---|---|---|
| U1 | AP2112K-3.3 | 600mA low dropout linear regulator, with enable pin, 3.8V-6V input voltage range, 3.3V fixed positive output, SOT-23-5 |
| U2 | MAX17048 | Fuela Gauge IC for Batteries |
| U3 | MCP73831 | Single cell, Li-Ion/Li-Po charge management controller, 4.50V, Tri-State Status Output, in SOT23-5 package |
| U4 | PCA9554PW | 8-bit I2C-bus and SMBus I/O port with interrupt, TSSOP-16 |
| U5 | OLED_1.3" | OLED display 1.3" view area 128x64 pixels |
| U7 | LM66200 | Dual ideal diode device with automatic switchover |
| C1,C10 | 10uF | Unpolarized capacitor |
| C2,C3,C9,C13,C16 | 0.1uF |
| Unpolarized capacitor |
| C4,C5,C12 | 4.7uF | Unpolarized capacitor |
|---|
| C6-C8,C11,C14 | 1.0uF | Unpolarized capacitor |
|---|
| C15 | 2.2uF | Unpolarized capacitor |
|---|
| D1 | Yellow | Light emitting diode |
|---|
| D3 | Red | Light emitting diode |
|---|
| FID1-FID4 | Fiducial_0.5mm | Fiducial Marker |
|---|
| G3,G5 | SparkFun_Logo |
|---|
| J1 | microSD_Friction | Micro SD socket External Pin |
|---|
| J2 | 1x10 |
|---|
| J3 | JST_2mm_LiPo | 2 Pin 2mm JST Battery Connector |
|---|
| J4 | 1x09 |
|---|
| JP1 | CHG | Solder Jumper, 2-pole, closed/bridged |
|---|
| JP2 | D/C | Solder Jumper, 2-pole, open |
|---|
| JP3 | PWR | Solder Jumper, 2-pole, closed/bridged |
|---|
| JP4 | I²C | Solder Jumper, 3-pole, pins 1+2+3 closed/bridged |
|---|
| JP5 | MEAS | Solder Jumper, 2-pole, closed/bridged |
|---|
| R1,R2,R5,R6,R8-R12 | 10k | Resistor |
|---|
| R3 | 2.0k | Resistor |
|---|
| R4,R14 | 1k | Resistor |
|---|
| R7 | 390k | Resistor |
|---|
| R13,R17 | 100k | Resistor |
|---|
| R15,R16 | 2.2k | Resistor |
|---|
| ST1-ST4 | Standoff | Drill holes for mechanically mounting via screws, standoffs, etc. |
|---|
| SW1 | SPDT_Slide_SMD_6.7x2.6mm | Switch, single pole double throw |
|---|
| SW2 | Nav Switch | Directional Pad |
|---|