SparkFun_Default_KiCad_Setup
sparkfun
A handful of example KiCad projects containing the defaults most used by SparkFun.
Components (21)
| Reference | Value | Description |
|---|---|---|
| Q1,Q2 | BSS138 | N-MOSFET transistor, drain/gate/source |
| U5 | AP3012 | 500mA, Adjustable Step-Up Voltage Regulator, 1.5MHz Frequency, SOT-23-5 |
| C1,C2 | 1.0uF | Unpolarized capacitor |
| D1 | Red | Light emitting diode |
| D2 | PMEG4005EJ | Schottky diode |
| FID1-FID4 | Fiducial_0.5mm | Fiducial Marker |
| G1 | qwiic_Logo | |
| G2,G3 | SparkFun_Logo | |
| J1,J2 | Qwiic_RA | 4 pin JST 1mm polarized connector for I2C |
| J3 | Conn_01x06 | Basic 0.1" PTH |
| JP1 | LED | Solder Jumper, 2-pole, closed/bridged |
| JP2 | I2C | Solder Jumper, 3-pole, pins 1+2+3 closed/bridged |
| JP3 | LOGIC | 3-pole Solder Jumper, pins 1+2 closed/bridged |
| JP4 | I2C HV | Solder Jumper, 3-pole, pins 1+2+3 closed/bridged |
| L1 | 10uH | Inductor |
| R1,R6 | 100k | Resistor |
| R2 | 33k | Resistor |
| R3 | 4.7k | Resistor |
| R4,R5,R7,R8 | 2.2k | Resistor |
| ST1-ST4 | Standoff | Drill holes for mechanically mounting via screws, standoffs, etc. |
| TP1,TP2 | 1.0mm | Test Point |