Shadowfax
someonelse20
FPV Drone designed from scrach.
Components (68)
| Reference | Value | Description |
|---|---|---|
| U1,U7 | STM32H523RCTx | STMicroelectronics Arm Cortex-M33 MCU, 256KB flash, 272KB RAM, 49 GPIO, LQFP64 |
| U2 | LSM6DSV | I2C/SPI, iNEMO inertial module: always-on 3D accelerometer and 3D gyroscope, with auxiliary SPI, 1.71V to 3.6V VCC |
| U3 | MMC5983MA | |
| U4 | BMP384 | |
| U5 | MIC5504-3.3YM5 | 300mA Low-dropout Voltage Regulator, Vout 3.3V, Vin up to 5.5V, SOT-23 |
| U6 | TPS54308 | 3A, 4.5 to 28V Input, EMI Friendly integrated switch synchronous step-down regulator, continuous-conduction, SOT-23-6 |
| U8,U11 | LR2021 | 137 MHz to 960 MHz 2.4GHz Low Power Long Range Transceive, LoRA, QFN-28 |
| U9 | STM32G030K8Tx | STMicroelectronics Arm Cortex-M0+ MCU, 64KB flash, 8KB RAM, 64 MHz, 2.0-3.6V, 29 GPIO, LQFP32 |
| U10 | MAX-M10S | GNSS Module MAX M10, VCC 1.65V to 3.6V |
| BOOT1,BOOT2,RESET1,RESET2 | SW_Push | Push button switch, generic, two pins |
| BT1 | MS621FE-FL11E | Single-cell battery |
| C1,C19,C21-C23,C41,C44,C61,C63,C74-C76 | 1uF | Unpolarized capacitor |
| C2,C3,C5,C15-C17,C31 | 10uF | Unpolarized capacitor |
| C4,C6-C8,C11,C12,C18,C20,C24,C25,C27,C29,C32,C40,C42,C43,C45-C48,C50,C53,C65,C69,C70 | 100nF | Unpolarized capacitor |
| C9,C14,C34,C37,C57,C83 | 18pF | Unpolarized capacitor |
| C10,C13,C35,C36 | 15pF | Unpolarized capacitor |
| C26,C28,C38,C39,C58,C60,C72,C73 | 2.2uF | Unpolarized capacitor |
| C30,C49,C55,C66,C71 | 4.7uF | Unpolarized capacitor |
| C33 | 47uF | Unpolarized capacitor |
| C51,C67,C68,C78 | 47pF | Unpolarized capacitor |
| C52 | 6.8pF | Unpolarized capacitor |
| C54 | 2.7pF | Unpolarized capacitor |
| C56 | 1.1pF | Unpolarized capacitor |
| C59 | 1.2pF | Unpolarized capacitor |
| C62 | 2pF | Unpolarized capacitor |
| C64,C77 | 1nF | Unpolarized capacitor |
| C79 | 22pF | Unpolarized capacitor |
| C80 | 2.2pF | Unpolarized capacitor |
| C81 | 7.5pF | Unpolarized capacitor |
| C82,C85 | 1.8pF | Unpolarized capacitor |
| C84 | 3.9pF | Unpolarized capacitor |
| D1,D2,D4-D6,D9-D11 | LED | Light emitting diode |
| D3,D8 | D_Schottky | Schottky diode |
| D7,D12 | D_TVS | Bidirectional transient-voltage-suppression diode |
| J1 | USB_C_Receptacle_USB2.0_14P | USB 2.0-only 14P Type-C Receptacle connector |
| J2-J5,J22,J27 | Conn_01x04 | Generic connector, single row, 01x04, script generated (kicad-library-utils/schlib/autogen/connector/) |
| J6 | Conn_01x05 | Generic connector, single row, 01x05, script generated (kicad-library-utils/schlib/autogen/connector/) |
| J7,J24,J28 | Conn_01x02 | Generic connector, single row, 01x02, script generated (kicad-library-utils/schlib/autogen/connector/) |
| J8-J21 | Conn_01x01 | Generic connector, single row, 01x01, script generated (kicad-library-utils/schlib/autogen/connector/) |
| J23 | Conn_01x08 | Generic connector, single row, 01x08, script generated (kicad-library-utils/schlib/autogen/connector/) |
| J25 | Micro_SD_Card_Det1 | Micro SD Card Socket with one card detection pin |
| J26,J29,J30 | Conn_Coaxial | coaxial connector (BNC, SMA, SMB, SMC, Cinch/RCA, LEMO, ...) |
| L1 | 10uH | Inductor |
| L2 | 18nH | Inductor |
| L3 | 1.5nH | Inductor |
| L4 | 1.6nH | Inductor |
| L5 | 1.1nH | Inductor |
| L6,L8 | 2.2uH | Inductor |
| L7 | 2.4nH | Inductor |
| L9 | 12nH | Inductor |
| L10 | 4.7nH | Inductor |
| L11 | 24nH | Inductor |
| L12 | 3.9nH | Inductor |
| L13 | 7.5nH | Inductor |
| R1,R2 | 5.1K | Resistor |
| R3,R10-R12,R14,R16,R17,R21 | 10K | Resistor |
| R4,R5,R18-R20,R25-R27 | 1.2K | Resistor |
| R6,R8 | 100K | Resistor |
| R7 | 33.2K | Resistor |
| R9 | 22K | Resistor |
| R13,R15,R24 | 1K | Resistor |
| R22,R23 | 120K | Resistor |
| TH1,TH2 | ERT-J0ER104F | Temperature dependent resistor, negative temperature coefficient |
| TP1,TP2 | TestPoint | test point |
| Y1,Y3 | 32.768MHz | Two pin crystal |
| Y2,Y4 | 24MHz | Four pin crystal, GND on pins 2 and 4 |
| Y5,Y7 | 32MHz 10pF | Four pin crystal, GND on pins 2 and 4 |
| Y6 | 32.768KHz | Two pin crystal |