synthesizer
rabidaudio
My custom synthesizer work
Components (50)
| Reference | Value | Description |
|---|---|---|
| Q1 | BSS214NW | 20V Vds, 1.5A Id, N-Channel MOSFET, SOT-323 |
| U1,U2,U4 | TL074 | Quad Low-Noise JFET-Input Operational Amplifiers, DIP-14/SOIC-14 |
| U3 | DG403 | Dual SPDT Monolithic CMOS Analog Switch, 45Ohm Ron, SOIC-16 |
| U6 | ATtiny24-20SS | 20MHz, 2kB Flash, 128B SRAM, 128B EEPROM, debugWIRE, SOIC-14 |
| C1-C3 | 10u | Unpolarized capacitor |
| C4-C10 | 100n | Unpolarized capacitor |
| D1,D3 | M_LED_RED | Light emitting diode |
| D2,D4 | S_LED_ORANGE | Light emitting diode |
| FID1 | C_SCREW_B | Fiducial Marker |
| FID2 | C_SCREW_T | Fiducial Marker |
| FID3 | M_SCREW_T | Fiducial Marker |
| FID4 | M_SCREW_B | Fiducial Marker |
| J1 | EURORACK_CONN_16 | |
| J2 | AUX_OUT | Audio Jack, 2 Poles (Mono / TS), Grounded Sleeve, Switched T Pole (Normalling) |
| J3 | AUX_IN_R | Audio Jack, 2 Poles (Mono / TS), Grounded Sleeve, Switched T Pole (Normalling) |
| J4 | AUX_IN_L | Audio Jack, 2 Poles (Mono / TS), Grounded Sleeve, Switched T Pole (Normalling) |
| J5 | MAIN_OUT_R | Audio Jack, 2 Poles (Mono / TS), Grounded Sleeve, Switched T Pole (Normalling) |
| J6 | MAIN_OUT_L | Audio Jack, 2 Poles (Mono / TS), Grounded Sleeve, Switched T Pole (Normalling) |
| J7,J9 | CHANNEL_IN | Audio Jack, 2 Poles (Mono / TS), Grounded Sleeve, Switched T Pole (Normalling) |
| J8 | AVR-ISP-6 | Atmel 6-pin ISP connector |
| J10 | C_BOARD_IN | Generic connector, single row, 01x08, script generated (kicad-library-utils/schlib/autogen/connector/) |
| J11 | INTERCONNECT1 | Generic connector, single row, 01x08, script generated (kicad-library-utils/schlib/autogen/connector/) |
| J12 | M_BOARD_IN | Generic connector, single row, 01x08, script generated (kicad-library-utils/schlib/autogen/connector/) |
| J13 | INTERCONNECT2 | Generic connector, single row, 01x08, script generated (kicad-library-utils/schlib/autogen/connector/) |
| J14 | C_BOARD_OUT | Generic connector, single row, 01x08, script generated (kicad-library-utils/schlib/autogen/connector/) |
| J15 | C_IN1 | |
| J16 | C_IN2 | |
| J17 | C_AUXSEND1 | |
| J18 | C_PAN1 | |
| J19 | C_AUXSEND2 | |
| J20 | C_PAN2 | |
| J21 | M_OUT_L | |
| J22 | M_AUXSEND | |
| J23 | M_AUX_AMOUNT | |
| J24 | M_OUT_R | |
| J25,J26 | M_AUX_RETURN_L | |
| J27 | M_MASTER | |
| R1,R6,R7,R10-R12,R25,R26,R29-R31 | 10k | Resistor |
| R2,R5,R17,R18,R20,R21 | 33k | Resistor |
| R3,R14,R15 | 100k | Resistor |
| R8,R9,R27,R28 | 1k | Resistor |
| RV1 | B100K - AUX_RETURN_LEVEL | Dual potentiometer, separate units |
| RV2 | A100K_MASTER_VOL | Dual potentiometer, separate units |
| RV3,RV7 | B1M_GAIN | Potentiometer |
| RV4,RV8 | A100K_CHANNEL_FADER | Potentiometer |
| RV5,RV9 | B1M_AUX_SEND | Potentiometer |
| RV6,RV10 | A100K_PAN | Dual potentiometer, separate units |
| SW1,SW4 | MUTE_PBSW | Push button switch, generic, two pins |
| SW2,SW5 | SOLO_PBSW | Push button switch, generic, two pins |
| SW3,SW6 | AUX_PRE_POST_FADER_SLIDESW | Switch, single pole double throw |