endeavour2
petrmikheev
The second generation of the Endeavour FPGA board
Components (73)
| Reference | Value | Description |
|---|---|---|
| Q1 | Q_NPN_BEC | NPN transistor, base/emitter/collector |
| U1 | Ti60F256 | |
| U2 | IM8G16D3FFBG | 8Gb (512Mx16 bit) Double Data Rate 3 Synchronous DRAM |
| U3 | TFP410PAP | |
| U4 | W25Q128JWS | 128Mb Serial Flash Memory, Standard/Dual/Quad SPI, SOIC-8 |
| U5 | FT2232HL | Hi Speed Double Channel USB UART/FIFO, LQFP-64 |
| U6,U7,U9 | AP22653W6-7 | |
| U8 | ESP32-C3-WROOM-02-N4 | |
| U10 | MCP4728 | |
| U11 | LM4811 | |
| U12 | PCF85063AT/AY | |
| U13 | STUSB4500QTR | Stand-alone USB PD controller (with sink Auto-run mode), QFN-24 |
| U14 | Si5351A-B-GT | |
| U15 | MC2520Z 25MHz | |
| U16,U23-U25 | SN74LVC1T45DCK | Single-Bit Dual-Supply Bus Transceiver With Configurable Voltage Translation and 3-State Outputs, SOT-363 |
| U17 | TPS2116DRLR | |
| U18-U22 | TPS562211DRLR | |
| BT1 | Battery_Cell | Single-cell battery |
| C1,C4,C9,C14,C17,C47-C50,C53,C54,C61-C63,C66,C87 | 1uF | Unpolarized capacitor |
| C2,C3 | 27pF | |
| C5,C19-C22,C25,C26,C29-C31,C41,C43,C44,C55-C60,C64,C65,C72-C76 | 0.1uF | Unpolarized capacitor |
| C6,C16 | 47uF | Unpolarized capacitor |
| C7,C12,C15,C18,C27,C32-C35,C37,C38 | 0.01uF | Unpolarized capacitor |
| C8,C11,C23,C28 | 4.7uF | Unpolarized capacitor |
| C10,C13,C24,C36,C39,C40,C42 | 10uF | Unpolarized capacitor |
| C45,C46,C51,C52 | 100uF | Polarized capacitor |
| C67-C71,C77-C86 | 22uF | Unpolarized capacitor |
| D1-D6,D9 | LED | Light emitting diode |
| D7,D8 | D | Diode |
| D10-D15 | D_TVS | Bidirectional transient-voltage-suppression diode |
| J1 | HDMI_A | |
| J2,J9 | USB_C_Receptacle_USB2.0 | |
| J3 | SJ-3523-SMT | |
| J4,J5 | USB_A | |
| J6 | Micro_SD_Card_Det2 | |
| J7 | Conn_02x04_Odd_Even | Generic connector, double row, 02x04, odd/even pin numbering scheme (row 1 odd numbers, row 2 even numbers), script generated (kicad-library-utils/schlib/autogen/connector/) |
| J8 | Conn_01x02 | Generic connector, single row, 01x02, script generated (kicad-library-utils/schlib/autogen/connector/) |
| J10 | jumper_power_source | Generic connector, single row, 01x03, script generated |
| J11 | Conn_GPIO | Generic connector, double row, 02x08, odd/even pin numbering scheme (row 1 odd numbers, row 2 even numbers), script generated (kicad-library-utils/schlib/autogen/connector/) |
| J12 | jumper_5v | Generic connector, single row, 01x03, script generated |
| J13 | Conn_power | Generic connector, single row, 01x06, script generated |
| J14 | Conn_01x04_Pin | Generic connector, single row, 01x04, script generated |
| JP1 | snd_power | |
| JP2,JP3 | Jumper_2_Bridged | Jumper, 2-pole, open |
| L1-L3 | 2.2uH | |
| L4,L5 | 4.7uH | |
| R1 | 240 | Resistor |
| R2-R4,R6-R13,R16,R18,R21-R24,R54,R58,R59,R71,R73,R74 | 10K | Resistor |
| R5 | 510 | Resistor |
| R14,R17,R35-R38,R75 | 25 | Resistor |
| R15 | 100K | Resistor |
| R19,R20,R55-R57,R60-R63 | 75 | Resistor |
| R25 | 12K | |
| R26 | 100 | Resistor |
| R27,R28,R51 | 1M | |
| R29,R30,R49,R50 | 5.1K | |
| R31,R32 | 60K | |
| R33,R34,R43,R44 | 15K | |
| R39-R42,R48,R52,R53 | 1K | Resistor |
| R45 | 200K | |
| R46,R47 | 1.5K | |
| R64 | 23.2K | Resistor |
| R65,R68 | 40.2K | Resistor |
| R66 | 24.9K | Resistor |
| R67,R69 | 20K | Resistor |
| R70 | 73.2K | Resistor |
| R72 | 45.3K | Resistor |
| SW1 | 204-124ST | |
| SW2,SW4,SW6 | SW_Push | Push button switch, generic, two pins |
| SW7,SW9 | SW_SPDT | Switch, single pole double throw |
| Y1 | 12MHz | |
| Y2 | Crystal | Two pin crystal |
| Y3 | 25MHz |