Loading design…
npgo22
| Reference | Value | Description |
|---|---|---|
| U1 | USBLC6-2SC6 | Very low capacitance ESD protection diode, 2 data-line, SOT-23-6 |
| U2 | STM32H563RIVx | STMicroelectronics Arm Cortex-M33 MCU, 2048KB flash, 640KB RAM, 250 MHz, 1.62-3.6V, 53 GPIO, VFQFPN68 |
| U3 | AP2112K-3.3 | 600mA low dropout linear regulator, with enable pin, 3.8V-6V input voltage range, 3.3V fixed positive output, SOT-23-5 |
| U4 | TCAN1462V | High-Speed CAN Transceiver, separate VIO, standby mode, SOIC-8 |
| U5 | LAN8742A | LAN8720 Ethernet PHY with RMII interface, QFN-24 |
| U6,U7 | ADS131A04 | |
| C1-C7,C19-C22,C25,C30-C33,C44-C47 | 100nF | Unpolarized capacitor, small symbol |
| C8,C9,C27,C28 | 10pF | Unpolarized capacitor, small symbol |
| C10,C11 | 2.2uF | Unpolarized capacitor, small symbol |
| C12-C17 | 22uF | Unpolarized capacitor, small symbol |
| C18,C23,C34,C35,C37,C38,C48,C49,C51,C52 | 1uF | Unpolarized capacitor, small symbol |
| C24 | 470pF | Unpolarized capacitor, small symbol |
| C26 | 220nF | Unpolarized capacitor, small symbol |
| C29,C36,C39,C42,C43,C50,C53,C56 | 10nF | Unpolarized capacitor, small symbol |
| C40,C41,C54,C55 | 30pF | Unpolarized capacitor, small symbol |
| D1-D6 | LED | Light emitting diode, small symbol |
| F1,F3,F4 | 500mA | Fuse, small symbol |
| F2 | 100mA Hold | Fuse, small symbol |
| J2 | USB_C_Receptacle_USB2.0_16P | USB 2.0-only 16P Type-C Receptacle connector |
| J3,J5 | Screw_Terminal_01x02 | Generic screw terminal, single row, 01x02, script generated (kicad-library-utils/schlib/autogen/connector/) |
| J4 | Conn_02x06_Top_Bottom | Generic connector, double row, 02x06, odd/even pin numbering scheme (row 1 odd numbers, row 2 even numbers), script generated (kicad-library-utils/schlib/autogen/connector/) |
| J6,J7,J10-J17 | Conn_02x01 | Generic connector, double row, 02x01, this symbol is compatible with counter-clockwise, top-bottom and odd-even numbering schemes., script generated (kicad-library-utils/schlib/autogen/connector/) |
| J8 | Screw_Terminal_01x05 | Generic screw terminal, single row, 01x05, script generated (kicad-library-utils/schlib/autogen/connector/) |
| J9 | RJ45_Hanrun_HR911105A_Horizontal | 1 Port RJ45 Magjack Connector Through Hole 10/100 Base-T, AutoMDIX |
| R1,R2 | 4.7k | Resistor, small US symbol |
| R3 | 150k | Resistor, small US symbol |
| R4-R10,R17,R19 | 10k | Resistor, small US symbol |
| R11 | 120R | Resistor, small US symbol |
| R12 | 1.5k | Resistor, small US symbol |
| R13-R16 | 47R | Resistor, small US symbol |
| R18 | 12.1k | Resistor, small US symbol |
| R20,R21 | 330R | Resistor, small US symbol |
| R22-R45 | 100R | Resistor, small US symbol |
| SW1 | SKRPANE010 | MEC 5E single pole normally-open tactile switch |
| Y1,Y2 | 25 MHz | Four pin crystal, GND on pins 2 and 4 |
| Y3,Y4 | 16.384 MHz | Four pin crystal, GND on pins 2 and 4 |