Loading design…
niektb
Published Modules of the Sluisbrinkie project
| Reference | Value | Description |
|---|---|---|
| U1 | FUSB302BMPX | Programmable USB Type-C Controller w/PD, I2C address 0x22, WQFN-14 |
| U2 | ATmega32U4-M | 16MHz, 32kB Flash, 2.5kB SRAM, 1kB EEPROM, USB 2.0, QFN-44 |
| U3,U4 | TMR-1212 | 165mA Regulated 2W DC/DC converter with 1.5kV isolation, 9V-18V input, 12V fixed Output Voltage, SIP-8 |
| U5 | L78M05ABDT | TO-252 5V 0.5A 3-terminal voltage regulator, Alternate KiCad Library |
| U6 | TPS26630RGE | 60V, 6A Power Limiting, Surge Protection Industrial eFuse, Adjustable Overvoltage cut-off, Active Current Limiting, VQFN-24 |
| C1,C6,C16,C20 | 1uF | Unpolarized capacitor |
| C2-C5,C15,C19 | 100nF | Unpolarized capacitor |
| C7 | 100n | Unpolarized capacitor |
| C8,C9,C12 | 1uF 50V | Unpolarized capacitor |
| C10,C11 | 22uF | Unpolarized capacitor |
| C13,C14 | 330pF | Unpolarized capacitor |
| C17,C18,C21 | 22uF 50V | Unpolarized capacitor |
|---|
| C22,C23 | 12pF | Unpolarized capacitor |
|---|
| D1 | SRV05-4 | SOT-23-6 TVS Diode Array, 4 protected lines, 5V, 300W, Alternate KiCAD Library |
|---|
| D2,D4 | LED | Light emitting diode |
|---|
| D3 | WS2812B | RGB LED with integrated controller |
|---|
| J1 | USB_C_Receptacle_USB2.0_16P | USB 2.0-only 16P Type-C Receptacle connector |
|---|
| J2 | Eurorack Power |
|---|
| J3 | Conn_02x03 | HEADER 2x3 MALE PINS 0.100” 180deg |
|---|
| JP1-JP4 | Jumper_2_Open | Jumper, 2-pole, open |
|---|
| R1,R2 | 27R | Resistor |
|---|
| R3 | 100k | Resistor |
|---|
| R4,R6,R12-R15 | 1k | Resistor |
|---|
| R5 | 330R | Resistor |
|---|
| R7,R16,R17,R21-R23 | 10k | Resistor |
|---|
| R8,R20 | 5k6 | Resistor |
|---|
| R9 | 33k | Resistor |
|---|
| R10 | 24k | Resistor |
|---|
| R11 | 390k | Resistor |
|---|
| R18 | 560k | Resistor |
|---|
| R19 | 82k | Resistor |
|---|
| SW1 | SW_Push | Push button switch, generic, two pins |
|---|
| Y1 | X322516MLB4SI | Four pin crystal, GND on pins 2 and 4 |
|---|