labathome
klaus-liebler
Components (117)
| Reference | Value | Description |
|---|---|---|
| Q1 | BC817 | |
| Q2,Q5,Q6 | IRLML6344 | 5.3A Id, 30V Vds, 27mOhm Rds, N-Channel HEXFET Power MOSFET, SOT-23 |
| Q3 | MJD31C | NPN transistor, base/collector/emitter |
| U1 | MAX3485 | True RS-485/RS-422, 10Mbps, Slew-Rate Limited, with low-power shutdown, with receiver/driver enable, 32 receiver drive capacitity, DIP-8 and SOIC-8 |
| U2 | IP5306_I2C | |
| U3 | DRV8313 | |
| U4 | ESP32-S3-WROOM-1 | |
| U5 | STM32G431R8Tx | STMicroelectronics Arm Cortex-M4 MCU, 64KB flash, 32KB RAM, 170 MHz, 1.71-3.6V, 52 GPIO, LQFP64 |
| U6 | RFM95W-868S2 | Low power long range transceiver module, SPI and parallel interface, 868 MHz, spreading factor 6 to12, bandwidth 7.8 to 500kHz, -111 to -148 dBm, SMD-16, DIP-16 |
| U7 | SN65HVD230 | |
| U8 | SRV05-4 | |
| U9 | LSM6DS3 | I2C/SPI, iNEMO inertial module: always-on 3D accelerometer and 3D gyroscope |
| U10 | NAU8822 | |
| U11 | AMS1117 | 1A Low Dropout regulator, positive, 3.3V fixed output, SOT-223 |
| U12 | AHT20 | |
| U13,U17 | DS18B20 | Programmable Resolution 1-Wire Digital Thermometer TO-92 |
| U14,U19,U20 | TMC2209 | Standalone driver for two-phase bipolar stepper motor, 2A, 4.75… 36V, UART, internal FETs, QFN28 |
| U15 | NRF24L01 | Ultra low power 2.4GHz RF Transceiver, Carrier PCB |
| U16 | LM358 | |
| U18 | TPS2116DRL | 2 Channnels Power Mux with Manual and Priority Switchover, 1.6-5.5V Input Voltage, 2.5A Output Current, Ron 40 mOhm, SOT-583-8 |
| U22 | AM612 | |
| U27 | TPS54202DDC | |
| BT1 | 18650 | Single-cell battery |
| C1,C4 | 10u | |
| C2,C3,C5,C11,C25-C27,C32-C35,C40,C45-C50,C53-C55,C57,C58,C60,C65,C66,C75,C87,C90,C91,C120 | u1 | Unpolarized capacitor |
| C6,C7,C28-C31,C56,C83,C84 | 22u | |
| C8-C10 | 10p | Unpolarized capacitor |
| C12-C15,C21,C22,C36,C41,C43 | 4u7 | Unpolarized capacitor |
| C16,C17,C20,C23,C24,C37,C42,C44,C59,C62,C67 | 1u | Polarized capacitor, small symbol,Unpolarized capacitor |
| C18,C19 | 220u | Polarized capacitor |
| C38 | 10n/35V | Unpolarized capacitor |
| C39 | 100u | Polarized capacitor |
| C51,C81 | u1/16V | Unpolarized capacitor |
| C52,C63,C68,C76,C79,C86,C89,C92,C98 | u1/35V | Unpolarized capacitor |
| C61 | 4u7/6V3 | Unpolarized capacitor |
| C64 | u1/24V | |
| C69,C72,C77,C78,C85,C88,C93,C96,C97,C102-C104 | 22u/35V | |
| C70,C73,C94 | 2u2 | Unpolarized capacitor |
| C71,C74,C95 | 22n/50V | Unpolarized capacitor |
| C80 | 10u/35V | |
| C82 | 56p | |
| D2 | PSM712 | Dual Line CAN Bus Protector, 24Vrwm |
| D3 | NUP2105 | |
| D8-D12 | WHITE | |
| D14 | HTR ON | |
| D15 | RGB2 | |
| D16 | RGB1 | |
| D17 | RGB0 | |
| D19 | INFO | |
| D20 | 1N5819WS | Diode |
| D21 | RGB3 | |
| FB1,FB2 | 600R | Ferrite bead, small symbol |
| J1 | HALL | |
| J2 | I2C | |
| J3 | AUX IN | Audio Jack, 3 Poles (Stereo / TRS), Switched T Pole (Normalling) |
| J4 | SCD4x | |
| J5 | USB_ESP32 | USB 2.0-only 16P Type-C Receptacle connector |
| J6 | PROG ESP | |
| J7 | FAN5V | |
| J8 | 3V GN RGB 5V | Generic connector, single row, 01x04, script generated (kicad-library-utils/schlib/autogen/connector/) |
| J9 | Barrel_Jack_Switch | DC Barrel Jack with an internal switch |
| J10 | BMEx80 | |
| J11 | QWIIC | Generic connectable mounting pin connector, single row, 01x04, script generated (kicad-library-utils/schlib/autogen/connector/) |
| J12 | TCS34725 | |
| J13 | USB STM32 | USB 2.0-only 16P Type-C Receptacle connector |
| J14 | AUX OUT | Audio Jack, 3 Poles (Stereo / TRS), Switched T Pole (Normalling) |
| J15 | CAN RS 485 | |
| J16 | Headphones | Audio Jack, 3 Poles (Stereo / TRS), Switched T Pole (Normalling) |
| J17 | Micro_SD_Card_Det1 | Micro SD Card Socket with one card detection pin |
| J18 | Bus-Servo | Generic connector, single row, 01x03, script generated (kicad-library-utils/schlib/autogen/connector/) |
| J19 | BH1750 | |
| J20 | CCS811 | |
| J21 | GPIO | |
| J22 | Volts | |
| J23 | VL53L0x | Generic connector, single row, 01x06, script generated (kicad-library-utils/schlib/autogen/connector/) |
| J24 | STEP1 | |
| J25 | Servos | Generic connector, double row, 02x09, odd/even pin numbering scheme (row 1 odd numbers, row 2 even numbers), script generated (kicad-library-utils/schlib/autogen/connector/) |
| J26 | EXT | Generic connector, double row, 02x03, odd/even pin numbering scheme (row 1 odd numbers, row 2 even numbers), script generated (kicad-library-utils/schlib/autogen/connector/) |
| J27 | ADDA | |
| J28 | Brushless | |
| J30 | STEP2 | |
| J31 | STEP3 | |
| J36 | PROG_STM | Generic connector, double row, 02x06, odd/even pin numbering scheme (row 1 odd numbers, row 2 even numbers), script generated (kicad-library-utils/schlib/autogen/connector/) |
| JP3 | LCD_RES | Jumper, 2-pole, closed/bridged |
| JP8 | Heater | Jumper, 2-pole, closed/bridged |
| JP9 | Fan | Jumper, 2-pole, closed/bridged |
| L1 | 1uH | |
| L4 | 10uH | |
| LS1 | Speaker | Speaker |
| M1 | W5500_mini | |
| MK1 | Mic | Condenser microphone |
| R1,R9,R40,R66,R70 | k22 | Resistor |
| R2,R4,R11,R17,R21,R26,R27,R29,R31,R36,R37,R39,R41,R45,R50,R51,R55-R58,R60-R65,R67,R68,R72,R75,R76,R81,R82,R85 | 10k | Resistor |
| R3,R7,R28,R47 | 1R | |
| R5,R6,R8,R12,R22,R30,R34,R35,R42,R69,R71,R74,R77 | 1k | Resistor |
| R10,R14,R16,R24 | 2k2 | Resistor |
| R13,R15,R78 | 10R | |
| R18,R19 | 5k1 | |
| R20,R46 | K12 | |
| R23 | 0R | Resistor |
| R25,R53,R54,R59 | M1 | Resistor |
| R32 | GL5516 | |
| R33 | 22R | |
| R38,R79,R80,R83,R84,R87,R88 | r1 | Resistor |
| R43,R44,R48,R49,R73 | 3k3 | |
| SW1 | Reset | |
| SW2 | ON RS TERM | Switch, single pole double throw |
| SW3 | ON CAN TERM | Switch, single pole double throw |
| SW5 | POWER | |
| SW6 | YELLOW | Rotary encoder, dual channel, incremental quadrate outputs, with switch and MP Pin |
| SW7 | RED | |
| SW8 | GREEN | |
| TP1 | G2 | test point |
| TP6 | G3 | test point |
| X1 | FAN_6024 | |
| X2 | Display_1.3inch | |
| X3 | SIM7080G |