| Q_AUTO1,Q_AUTO2 | SS8050 | TRANS NPN 25V 1.5A SOT23 |
|---|
| Q_HALL1,Q_SERVO1 | BSS138LT3G | MOSFET N-CH SOT23 |
|---|
| Q_POW1 | SQ2351ES-T1_GE3 | MOSFET P-CH 20V 3.2A SOT23-3 |
|---|
| Q_POW2,Q_POW3 | MMBT3904,215 | BJT |
|---|
| U_MCU1 | ESP32-WROOM-32 | ESP32 |
|---|
| U_POW2 | AZ1117CH-3.3TRG1 | REG LINEAR 3.3V 800MA SOT223 |
|---|
| U_SER1 | FT231XS-R | Serial communication IC |
|---|
| U_STP1 | ULN2003 | Driver |
|---|
| U_USB1 | USB6B1 | USB-C TVS diode |
|---|
| A_NEMA1 | 8+8 pin | Driver breakout |
|---|
| C_ENA1,C_MCU1,C_RST1,C_SER1,C_SER4,C_WIFI1 | 0.1uF 10V | Debounce,Decouple |
|---|
| C_MCU2,C_POW2,C_POW3 | 22uF 12V 1mOhm | Debounce,Decouple |
|---|
| C_NEMA1 | 100uF 25V | Decouple |
|---|
| C_NEMA2,C_POW1,C_SER5,C_STP1 | 10uF 12V 5mOhm | Decouple |
|---|
| C_POW_6V_FF1 | 82pF 100V | Feedback |
|---|
| C_POW_BST1,C_POW_BST3 | 0.1uF 50V | Boost |
|---|
| C_POW_BST2 | 0.33uF 50V | Boost |
|---|
| C_POW_IN1-C_POW_IN3 | 10uF 25V | Decouple |
|---|
| C_POW_OUT1-C_POW_OUT5 | 22uF 25V | Decouple |
|---|
| C_SER2,C_SER3 | 47pF 5V | Filter |
|---|
| D_HALL1,D_NEMA1,D_NEMA2,D_POW1,D_POW2,D_RX1,D_SERVO1,D_STP1-D_STP4,D_TX1,D_USB1 | LED white | LED on,LED output,LED standby,RX LED,Signal LED,TX LED,USB-C power LED |
|---|
| FB_USB1 | 40 Ohms @ 100 MHz 1 Power | Ferrite bead |
|---|
| F_USB1 | 6V 750mA | USB-C Polyfuse |
|---|
| H1-H4,H6 | M3 | Mounting hole pad |
|---|
| JP1,JP2 | SolderJumper_2_Open | |
|---|
| JP_SER1,JP_SER3 | Bridged | Solder jumper |
|---|
| J_28byj-48-12v_1 | Conn_01x05_Male | Header |
|---|
| J_B_6v_1,J_B_12v_1,J_B_GND_1,TP_3.3v1,TP_5v1,TP_6v1,TP_12v1,TP_GND3 | TestPoint | Testing point |
|---|
| J_EXT1,J_SERVO1 | Conn_01x03_Male | Header |
|---|
| J_HALL1 | Conn_01x03_Female | Header |
|---|
| J_LEDE1,J_LEDP1 | Conn_01x02_Male | Header |
|---|
| J_NEMA1,J_OLED1 | Conn_01x04_Male | Header |
|---|
| J_POW1 | Barrel_Jack_Switch | DC jack |
|---|
| J_USB1 | USB4105-GF-A | USB-C port |
|---|
| LS1 | CSS-0575A-SMT | 5 mm, 3 V, 75 dB, Surface Mount _SMT_, Magnetic Audio Transducer Buzzer |
|---|
| R_AUTO1,R_AUTO2,R_ENA1,R_HALL1,R_HALL2,R_RST1,R_SERVO1,R_SERVO2 | 10K (5%) | Pullup |
|---|
| R_HALL3,R_LEDE1,R_LEDP1,R_NEMA1,R_NEMA2,R_RX1,R_SER1,R_SER2,R_SERVO3,R_TX1 | 27R | Filter,LED series resistor,RX LED series resistor,TX LED series resistor |
|---|
| R_POW1,R_POW6,R_STP1-R_STP4 | 430R | LED resistor,LED series resistor |
|---|
| R_POW2,R_POW3,R_POW5,R_POW_FBT1 | 100K | |
|---|
| R_POW4 | 1M | |
|---|
| R_POW_FFB1 | 11K | Feedback |
|---|
| R_USB1,R_USB2 | 5.1K (10%) | USB-C config resistor |
|---|
| R_USB3 | 100R | USB-C power LED resistor |
|---|
| R_WIFI1 | 10K(5%) | Pullup |
|---|
| SW_ENA1,SW_POW1,SW_RST1,SW_WIFI1 | B3FS-1000 | Momentary switch,On-off switch |
|---|
