Loading design…
gerbilbyte
The successor to the original DeMoN cart for the Amiga 500 and Amiga 500+ computers.
| Reference | Value | Description |
|---|---|---|
| U1 | ATF1508AS-15JC84 | High-density, High-performance, Electrically-erasable Complex Programmable Logic Device 64 Macrocells 5 Product Terms per Macrocell, Expandable up to 40 per Macrocell 44, 68, 84, 100 Pins 7.5 ns Maximum Pin-to-pin Delay Registered Operation up to 125 MHz Enhanced Routing Resources In-System Programmability (ISP) via JTAG Flexible Logic Macrocell D/T/Latch Configurable Flip-flops Global and Individual Register Control Signals Global and Individual Output Enable Programm |
| U2 | MC1455B | Timer, 555 compatible, SOIC-8 |
| U3,U5 | AT29C010A-90JI | Fast Read Access Time 70 ns 5-volt Only Reprogramming Sector Program Operation Single Cycle Reprogram (Erase and Program) 1024 Sectors (128 Bytes/sector) Internal Address and Data Latches for 128 Bytes Two 8K Bytes Boot Blocks with Lockout Internal Program Control and Timer Hardware and Software Data Protection Fast Sector Program Cycle Time 10 ms DATA Polling for End of Program Detection Low Power Dissipation 50 mA Active Current 100 A CMOS Standby Current T |
| U4,U6 | IS61C5128AS-25QLI | SRAM 4Mb,High-Speed,Low Power,Async,512K x 8,25ns,5v,32 Pin SOP (450 mil), RoHS |
| U7 | FT240XS | Full Speed USB to 8-Bit FIFO, SSOP-24 |
| C1 | 10uF | Polarized capacitor |
| C2 | 1uF | Polarized capacitor |
| C3,C6-C17 | 100nF | Unpolarized capacitor |
| C4,C5 | 47pF | Unpolarized capacitor |
| CN1 | ECC43DCAI-S189 | CONN EDGE DUAL FMALE 86POS 0.100 |
| D1 | D | Diode |
| D2,D3 | LED | Light emitting diode |
| J1 | USB4110-GF-A | CONN USB 2.0 TYPE-C R/A SMT |
| R1 | 4.7k | Resistor |
| R2,R3 | 220R | Resistor |
| R4-R6,R9,R11,R13 | 1k | Resistor |
| R7,R8 | 27R | Resistor |
| R10,R12 | 5.1K | Resistor |
| SW1 | SW_Push | Push button switch, generic, two pins |
| SW2 | SW_Wuerth_450301014042 | Switch slide, single pole double throw |
| VR1 | RV09AF-40-20K-B1M | Potentiometers 20mm Linear 1MM |