| Q1 | BSS123 | SOT-23 N-MOSFET enchancement mode transistor, 100V, 170mA, 360mW, Alternate KiCAD Library |
|---|
| U2 | 74LVC1G18 | Single Demultiplexer, Low-Voltage CMOS |
|---|
| U3,U12 | USBLC6-2SC6 | Very low capacitance ESD protection diode, 2 data-line, SOT-23-6 |
|---|
| U5,U6 | TPS22919 | 2.7..18V, 2A, 79mohms On-Resistance Load Switch With Thermal Protection, SOT-23-6 |
|---|
| U7 | INA226 | High-Side or Low-Side Measurement, Bi-Directional Current and Power Monitor (0-36V) with I2C Compatible Interface, VSSOP-10 |
|---|
| U8 | TLV76733DRVx | 1A Precision Linear Voltage Regulator, with enable pin, Fixed Output 3.3V, WSON6 |
|---|
| U9 | STM32F405RGTx | STMicroelectronics Arm Cortex-M4 MCU, 1024KB flash, 192KB RAM, 168 MHz, 1.8-3.6V, 51 GPIO, LQFP64 |
|---|
| U10 | SN74LVC2T45DCUR | Dual-Bit Dual-Supply Bus Transceiver With Configurable Voltage Translation and 3-State Outputs, VSSOP-8 |
|---|
| U11 | TS3USB30ERSWR | ESD-Protected, High-Speed USB 2.0 (480-Mbps) 1:2 Multiplexer/Demultiplexer Switch With Single Enable, UQFN-10 |
|---|
| U13 | TS5A3159DBV | Single SPDT Analog Switch, 1.65-V to 5.5-V Single-Supply Operation, 1Ohm Ron, SOT-23-6 |
|---|
| U14 | MCP2542FDxMF | CAN-FD Transceiver, Wake-Up on CAN activity, 8Mbps, 5V supply, STBY pin, 3x3 DFN-8 |
|---|
| C1,C16 | 10uF | Unpolarized capacitor |
|---|
| C2 | 22uF | Unpolarized capacitor |
|---|
| C3-C10,C13,C18,C25,C27-C30,C33,C34 | 100nF | Unpolarized capacitor |
|---|
| C11 | 4.7nF/2kV | Unpolarized capacitor |
|---|
| C12 | 10nF | Unpolarized capacitor |
|---|
| C14,C15,C26 | 4.7uF | Unpolarized capacitor |
|---|
| C17,C32 | 1uF | Unpolarized capacitor |
|---|
| C19-C22 | 12pF | Unpolarized capacitor |
|---|
| C23,C24,C31 | 2.2uF | Unpolarized capacitor |
|---|
| D1 | SRV05-4 | SOT-23-6 TVS Diode Array, 4 protected lines, 5V, 300W, Alternate KiCAD Library |
|---|
| D2 | PTVS5V0S1UTR | SOD-123F Unidirectional TVS diode, 5V, 400W, Alternate KiCAD Library |
|---|
| D3-D5 | ESD5Z5V0 | SOD-523 Unidirectional TVS diode, 5V, 148W, Alternate KiCAD Library |
|---|
| D6 | PESD2CAN | SOT-23 Dual bidirectional TVS diode for CAN bus protection, 24V, 230W, Alternate KiCAD Library |
|---|
| D7 | SMF5.0A | Unidirectional TVS diode, Generic symbol, Alternate KiCAD Library |
|---|
| F1 | 1A | Resettable fuse, polymeric positive temperature coefficient, small symbol |
|---|
| F2 | 2A | Resettable fuse, polymeric positive temperature coefficient, small symbol |
|---|
| FB2 | 33Ohm @100 MHz | Ferrite bead |
|---|
| J1 | Conn_Comm | Generic connector, single row, 01x06, script generated (kicad-library-utils/schlib/autogen/connector/) |
|---|
| J2 | USB_C | USB 2.0-only 16P Type-C Receptacle connector |
|---|
| J3 | Conn_CAN | Generic connector, single row, 01x06, script generated (kicad-library-utils/schlib/autogen/connector/) |
|---|
| J4 | Conn_JTAG/SWD | Generic connector, double row, 02x05, odd/even pin numbering scheme (row 1 odd numbers, row 2 even numbers), script generated (kicad-library-utils/schlib/autogen/connector/) |
|---|
| J5 | Conn_MCU_PROG | Generic connector, single row, 01x04, script generated (kicad-library-utils/schlib/autogen/connector/) |
|---|
| L1 | 470nH | Inductor |
|---|
| R1,R8 | 1M | Resistor |
|---|
| R2 | 100m | Resistor |
|---|
| R3,R4 | 10 | Resistor |
|---|
| R5,R6 | 4.7k | Resistor |
|---|
| R7,R11,R12 | 0 | Resistor |
|---|
| R9,R10 | 5.1k | Resistor |
|---|
| R13,R14 | 10k | Resistor |
|---|
| R15,R16 | 22 | Resistor, small symbol |
|---|
| R17,R19,R22 | 100k | Resistor, small symbol |
|---|
| R18,R20 | 1k | Resistor,Resistor, small symbol |
|---|
| R21 | 120R | Resistor |
|---|
| SW1,SW2 | SW_Push | Push button switch, generic, two pins |
|---|
| TP2 | 5V | test point |
|---|
| X2 | 12MHz | Quartz crystal, Shielded, Generic symbol, Alternate KiCad Library |
|---|
| Y1 | 25MHz | Two pin crystal |
|---|
