msxxx
cinepost
MSX2+ FPGA implementation with bells and whistles.
Components (53)
| Reference | Value | Description |
|---|---|---|
| Q1 | AO3400A | 30V Vds, 5.7A Id, N-Channel MOSFET, SOT-23 |
| U1 | ADV7123 | |
| U2 | AD8073JNZ | |
| U3 | AD725 | Low Cost RGB to NTSC/PAL Encoder with Luma Trap Port |
| U4,U10,U14,U15 | 74HC597 | 8-bit serial in/out Shift Register 3-State Outputs |
| U5 | EP1C12Q240C8N | FPGA Cyclone® Family 12060 Cells 275.03MHz 130nm Technology 1.5V 240-Pin PQFP Tray |
| U6 | RP2354B | A microcontroller by Raspberry Pi, dual CPU architecture (ARM Cortex-M33 / RISC-V Hazard3), 150MHz, 2MB flash, 520KB SRAM, 12 PIO state machines, VQFN-80 |
| U7 | IP2721 | USB TYPEC PD Controller Interface, TSSOP-16 |
| U8 | OLED SCREEN | |
| U9 | AMS1117-1.5 | 1A Low Dropout regulator, positive, 1.5V fixed output, SOT-223 |
| U11 | AMS1117-3.3 | 1A Low Dropout regulator, positive, 3.3V fixed output, SOT-223 |
| U12 | MCP23008-xML | 8-bit I/O expander, I2C, interrupts, QFN-20 |
| U13 | M51953BFP | |
| U17 | FE1.1s | USB 2.0 High Speed 4-Port Hub Controller, SSOP-28 |
| U18 | CS4398 | 120-dB, 192-kHz Multibit DAC with Volume Control |
| U19 | NE5532 | Dual Low-Noise Operational Amplifiers, DIP-8/SOIC-8 |
| U22 | MT48LC16M16A2TG | 256M – (16M x 16 bit) Synchronous DRAM (SDRAM), TSOP-II-54 |
| U23 | 25CS320 | 32Kbit SPI Serial EEPROM, SOIC-8 |
| C1,C9,C11,C42,C44,C47,C48,C58 | 100n | Unpolarized capacitor |
| C2-C6,C8,C10,C13,C14,C19,C21,C22,C24-C26,C28,C29,C32-C41,C45,C46,C56,C61 | C | Unpolarized capacitor |
| C7,C12,C15-C17,C23,C27,C57,C63 | C_Polarized | Polarized capacitor |
| C18,C43,C55 | 10uF | Polarized capacitor,Unpolarized capacitor |
| C20 | 1uF | Unpolarized capacitor |
| D5-D9 | LED | Light emitting diode |
| J1 | USB_C_Receptacle_PowerOnly_6P | USB Power-Only 6P Type-C Receptacle connector |
| J2 | DH15 | |
| J3 | AudioJack2_Ground | Audio Jack, 2 Poles (Mono / TS), Grounded Sleeve |
| J4 | Conn_Coaxial | coaxial connector (BNC, SMA, SMB, SMC, Cinch/RCA, LEMO, ...) |
| J5 | Conn_01x05 | Generic connector, single row, 01x05, script generated (kicad-library-utils/schlib/autogen/connector/) |
| J6 | MD-40SM | |
| J7 | Conn_02x25_Odd_Even | Generic connector, double row, 02x25, odd/even pin numbering scheme (row 1 odd numbers, row 2 even numbers), script generated (kicad-library-utils/schlib/autogen/connector/) |
| J8 | JOY_0 | 9-pin D-SUB connector, socket (female), Mounting Hole |
| J9 | Micro_SD_Card_Det1 | Micro SD Card Socket with one card detection pin |
| J10 | JOY_2 | 9-pin D-SUB connector, socket (female), Mounting Hole |
| J11 | ESP-01 | Generic connector, double row, 02x04, odd/even pin numbering scheme (row 1 odd numbers, row 2 even numbers), script generated (kicad-library-utils/schlib/autogen/connector/) |
| J12 | JOY_1 | 9-pin D-SUB connector, socket (female), Mounting Hole |
| J13 | Conn_01x02 | Generic connector, single row, 01x02, script generated (kicad-library-utils/schlib/autogen/connector/) |
| J15 | JOY_3 | 9-pin D-SUB connector, socket (female), Mounting Hole |
| J16,J17 | 2x USB A | |
| R1-R3,R5,R7-R14,R16,R20-R23,R43-R49,R53-R63 | R | Resistor |
| R4,R6 | 5k1 | Resistor |
| R15,R35,RN12-RN16,RN19 | 10K | 4 resistor network, parallel topology,Resistor |
| R17 | 10 | Resistor |
| R18,R19 | 100 | Resistor |
| R24-R27 | 220 | Resistor |
| R28,R31-R34,R37,R38 | 33R | Resistor |
| R51 | 2k7 | Resistor |
| RN1-RN11,RN21-RN23 | R_Pack04_Split | 4 resistor network, parallel topology, split |
| SW1,SW2,SW4,SW9 | SW_MEC_5G | MEC 5G single pole normally-open tactile switch |
| SW3 | SW_Push | Push button switch, generic, two pins |
| X2 | SCART-F | |
| Y2 | Crystal_GND24 | Four pin crystal, GND on pins 2 and 4 |
| Y3 | 21.47727 MHz | CMOS Clock Oscillator 2.5 to 50 MHz |