Loading design…
benediktibk
| Reference | Value | Description |
|---|---|---|
| IC1-IC4 | LT8584EFE#PBF | |
| IC5 | RESET | 6 x 6 mm, 5 mm Actuator Height, 100 gf, Black, Short Crimped, Through Hole, SPST, Tactile Switch |
| Q1,Q2 | TJ40S04M3L | P-MOSFET transistor, drain/gate/source |
| Q3-Q7,Q9,Q14 | DMN3404L | n-MOSFET transistor, drain/gate/source |
| Q8,Q10-Q13 | BS250FTA | P-MOSFET transistor, drain/gate/source |
| U1 | STC3100 | battery fuel gauge |
| U2,U3 |
| 700mA Micropower Low Dropout Linear Regulator, adjustable output voltage, SO-8 |
| U4,U5 | ICL7660 | charge pump |
|---|
| U6 | FT230XS | Full Speed USB to Basic UART, SSOP-16 |
|---|
| U7 | STM32L071CZTx | ARM Cortex-M0+ MCU, 192KB flash, 20KB RAM, 32MHz, 1.65-3.6V, 37 GPIO, LQFP-48 |
|---|
| U8 | AT24C512C | I2C Serial EEPROM, 2Kb, SOT-23 |
|---|
| U9 | NCT75DR2G | I2C Serial EEPROM, 2Kb, SOT-23 |
|---|
| U10,U11 | LM2904M8-13 | Dual Rail-to-Rail High Output Current Operational Amplifiers, SOIC-8/TSSOP-8 |
|---|
| C1,C3,C7,C17,C18,C21,C23-C27,C29-C32,C34,C36-C39 | 100nF | Unpolarized capacitor |
|---|
| C2,C6,C10,C28,C33,C35,C42,C49,C56,C63 | 1uF | Unpolarized capacitor |
|---|
| C4,C8,C41,C45,C48,C52,C55,C59,C62,C66 | 47uF | Unpolarized capacitor |
|---|
| C5,C9,C11-C14,C22,C43,C44,C50,C51,C57,C58,C64,C65 | 10uF | Unpolarized capacitor |
|---|
| C15 | 10nF | Unpolarized capacitor |
|---|
| C16 | 4.7uF | Unpolarized capacitor |
|---|
| C19,C20 | 47pF | Unpolarized capacitor |
|---|
| C40,C47,C54,C61 | 22nF | Unpolarized capacitor |
|---|
| C46,C53,C60,C67 | 47nF | Unpolarized capacitor |
|---|
| D1,D2,D4-D11 | BAT54WS | Schottky diode |
|---|
| D3,D17-D20 | SBR2065D1 | Schottky diode |
|---|
| D12 | UART_TX | Light emitting diode |
|---|
| D13 | UART_RX | Light emitting diode |
|---|
| D14 | green | Light emitting diode |
|---|
| D15 | red | Light emitting diode |
|---|
| D16 | yellow | Light emitting diode |
|---|
| F1 | 20A | Fuse |
|---|
| FB1,FB2 | BLM18P | Ferrite bead |
|---|
| H1-H4 | MountingHole_Pad | Mounting Hole with connection |
|---|
| H5-H11 | heatsink_18x18 |
|---|
| J1 | VBAT_DISCHARGE | Generic connector, single row, 01x02, script generated (kicad-library-utils/schlib/autogen/connector/) |
|---|
| J2 | CELLS | Generic connector, single row, 01x05, script generated (kicad-library-utils/schlib/autogen/connector/) |
|---|
| J3 | Charge | Generic connector, single row, 01x02, script generated (kicad-library-utils/schlib/autogen/connector/) |
|---|
| J4 | Discharge | Generic connector, single row, 01x02, script generated (kicad-library-utils/schlib/autogen/connector/) |
|---|
| J5 | AMPHENOL_micro_usb_10118194-0001LF |
|---|
| J6 | ARM-JTAG-SWD | Cortex M JTAG/SWD 10 pin connector |
|---|
| J7 | TEMP_CELL1 | Generic connector, single row, 01x04, script generated (kicad-library-utils/schlib/autogen/connector/) |
|---|
| J8 | TEMP_CELL2 | Generic connector, single row, 01x04, script generated (kicad-library-utils/schlib/autogen/connector/) |
|---|
| J9 | TEMP_CELL3 | Generic connector, single row, 01x04, script generated (kicad-library-utils/schlib/autogen/connector/) |
|---|
| J10 | TEMP_CELL4 | Generic connector, single row, 01x04, script generated (kicad-library-utils/schlib/autogen/connector/) |
|---|
| L1,L2 | RLB0914-220KL | Fixed Inductors 22uH 10% 1.9A |
|---|
| R1-R4,R33,R34,R37,R40 | 220kOhm | Resistor |
|---|
| R5 | 2mOhm/5W | Resistor |
|---|
| R6 | 200kOhm | Resistor |
|---|
| R7,R11 | 390kOhm | Resistor |
|---|
| R8,R12,R19-R24,R30-R32 | 10kOhm | Resistor |
|---|
| R9,R35,R36,R38,R44 | 100kOhm | Resistor |
|---|
| R10,R14 | 39kOhm | Resistor |
|---|
| R13 | 43kOhm | Resistor |
|---|
| R15,R16 | 27Ohm | Resistor |
|---|
| R17,R18 | 120Ohm | Resistor |
|---|
| R25,R26,R45-R48 | 4.7kOhm | Resistor |
|---|
| R27-R29 | 100Ohm | Resistor |
|---|
| R39,R41 | 24kOhm | Resistor |
|---|
| R42 | 36kOhm | Resistor |
|---|
| R43 | 68kOhm | Resistor |
|---|
| T1-T4 | NA6252-ALD |
|---|