trickortrace
arsoninstigator
Components (39)
| Reference | Value | Description |
|---|---|---|
| Q1-Q4 | IRLML0030 | N-MOSFET transistor, gate/drain/source |
| U1 | STM32F411VETx | STMicroelectronics Arm Cortex-M4 MCU, 512KB flash, 128KB RAM, 100 MHz, 1.7-3.6V, 81 GPIO, LQFP100 |
| U2 | MAX-M10S | GNSS Module MAX M10, VCC 1.65V to 3.6V |
| U3 | BMP390 | |
| U4 | BMI088 | |
| U5 | LMR33640DDDA | Simple Switcher Synchronous Buck Regulator, Vin=3.8-36V, Iout=4A, F=1000kHz, Adjustable output voltage, HSOP-8 |
| U6 | TLV76133DCY | 3.3V, 1A, Low Noise, High-PSRR LDO Regulator, 2.5V...16V input, SOT-223 |
| U7 | W25Q512JV | |
| U8 | Ai-Thinker-Ra-02 | Ai-Thinker Ra-02 410-525 MHz LoRa Module, SPI interface, U.FL antenna connector |
| C1-C7,C15-C18,C24,C31-C33 | 100n | Unpolarized capacitor |
| C8 | 10n | Unpolarized capacitor |
| C9,C10,C19,C23,C29 | 1u | Unpolarized capacitor |
| C11,C12 | 4.7u | Unpolarized capacitor |
| C13,C14,C25 | 10p | Unpolarized capacitor |
| C20 | 2.2u | Unpolarized capacitor |
| C21 | 10u | Unpolarized capacitor |
| C22 | 220n | Unpolarized capacitor |
| C26-C28,C30 | 22u | Polarized capacitor,Unpolarized capacitor |
| D1 | WS2812S | RGB LED with integrated controller |
| FB1 | 120R | Ferrite bead |
| J1 | BAT | Generic screw terminal, single row, 01x02, script generated (kicad-library-utils/schlib/autogen/connector/) |
| J2 | USB_B_Micro | USB Micro Type B connector |
| J3 | Micro_SD_Card | Micro SD Card Socket |
| J5 | Pyro_1 | Generic screw terminal, single row, 01x02, script generated (kicad-library-utils/schlib/autogen/connector/) |
| J6 | Pyro_2 | Generic screw terminal, single row, 01x02, script generated (kicad-library-utils/schlib/autogen/connector/) |
| J7 | Pyro_3 | Generic screw terminal, single row, 01x02, script generated (kicad-library-utils/schlib/autogen/connector/) |
| J8 | Pyro_4 | Generic screw terminal, single row, 01x02, script generated (kicad-library-utils/schlib/autogen/connector/) |
| J9 | I2C | Generic screw terminal, single row, 01x02, script generated (kicad-library-utils/schlib/autogen/connector/) |
| J10 | SPI | Generic screw terminal, single row, 01x03, script generated (kicad-library-utils/schlib/autogen/connector/) |
| J11-J13 | GPIO | Generic screw terminal, single row, 01x02, script generated (kicad-library-utils/schlib/autogen/connector/) |
| L1 | 3.3u | Inductor |
| M1 | WHEEL | Servo Motor (Futaba, HiTec, JR connector) |
| M2-M5 | Motor_Servo | Servo Motor (Futaba, HiTec, JR connector) |
| R1,R10,R12,R14,R16 | 10k | Resistor |
| R2-R9,R11,R13,R15,R17 | 4.7k | Resistor |
| R18,R19 | 100k | Resistor |
| R20 | 24.9k | Resistor |
| SW1,SW2 | SW_SPDT | Switch, single pole double throw |
| Y1 | 16 MHz | Four pin crystal, GND on pins 2 and 4 |