CamperVan
akladnig
Components (84)
| Reference | Value | Description |
|---|---|---|
| Q1-Q4,Q7 | STP40NF30L | 40A Id, 30V Vds, 22mOhm Rds, N-Channel HEXFET Power MOSFET, TO-220AB |
| Q5,Q6,Q8 | 2N2222 | 0.1A Ic, 50V Vce, Low Noise General Purpose NPN Transistor, TO-18 |
| U3,U10 | DS18B20 | Programmable Resolution 1-Wire Digital Thermometer TO-92 |
| U4,U21,U26-U28 | ILQ615-3 | Quad Optocoupler, NPN Phototransistor Output, TTL compatible, DIP16/SMD16 |
| U5-U9,U20,U22 | CNY17-3 | DC Optocoupler Base Connected, Vce 70V, CTR 100-200%, Viso 5000V (RMS), DIP6 |
| U11,U19 | MCP6004 | 1MHz, Low-Power Op Amp, DIP-14/SOIC-14/TSSOP-14 |
| U12 | MCP6002-xP | 1MHz, Low-Power Op Amp, DIP-8 |
| U13,U25,U30 | LM7805 | Positive 1A 35V Linear Regulator, Fixed Output 5V, TO-220 |
| U14,U23,U29 | BA00 | Adjustable voltage and current regulator, 2A, 36V |
| U15,U16,U18 | IL300 | Isolated Linear Photocoupler, High Gain, Wideband, DIP8/SMD-DIP8 |
| U17,U24 | RS485-TTL | 20Mbps, 3.3V RS-485 transceiver, ±15-kV IEC ESD protection, -7V..+12V common mode voltage, SO-8 |
| U31 | IPS 3.5" Display | ILI9341 controller, SPI TFT LCD Display, 9-pin breakout PCB, 4-pin SD card interface, 5V/3.3V |
| A1 | Alternator 180A | DC Motor |
| A2-A4 | Arduino_Nano_ESP32 | Arduino Nano board based on the ESP32-S3 with a dual-core 240 MHz processor, 384 kB ROM, 512 kB SRAM. Operates at 3.3V, with 5V USB-C® input and 6-21V VIN. Features Wi-Fi®, Bluetooth® LE, digital and analog pins, and supports SPI, I2C, UART, I2S, and CAN. |
| C1-C11,C22,C25,C27,C29-C31,C35-C48 | 100nF | Unpolarized capacitor, small symbol |
| C12,C13,C28,C33,C49,C51 | 0.33uF | Polarized capacitor, small US symbol |
| C14-C19,C21,C24,C26 | 1uF | Unpolarized capacitor |
| C20,C34,C52 | 0.1uF | Polarized capacitor, small US symbol |
| C23,C32,C50 | 22uF | Polarized capacitor, small US symbol |
| D1,D3-D6 | 1N4001 | 50V 1A General Purpose Rectifier Diode, DO-41 |
| D2,D7 | 1N914 | 100V 0.3A Small Signal Fast Switching Diode, DO-35 |
| F1 | 100A | Fuse |
| F2 | 30A | Fuse |
| F3,F4 | 60A | Fuse |
| F5,F6 | 200A | Fuse |
| F7 | ANL 50A | Fuse |
| F8 | ANL 250A | Fuse |
| F9 | 5A | Fuse |
| F10-F15 | 10A | Fuse |
| F16,F17 | 15A | Fuse |
| J1,J4,U1 | Input Flow Sensor | Generic connector, single row, 01x03, script generated,Programmable Linear Hall Effect Sensor, +0.6 to +1.3mV/G, SIP-4 |
| J2,J5,U2 | Output Flow Sensor | Generic connector, single row, 01x03, script generated,Programmable Linear Hall Effect Sensor, +0.6 to +1.3mV/G, SIP-4 |
| J3,J35 | Starter Battery | Generic connector, single row, 01x01, script generated |
| J6,J30,J34,SW11 | Solar Panel 2 | Generic connector, single row, 01x02, script generated,Single Pole Single Throw (SPST) switch |
| J7 | Ignition | Generic connector, single row, 01x01, script generated |
| J8,J9 | RS485 | Generic connector, single row, 01x02, script generated |
| J10,J11 | Fans | Generic connector, single row, 01x04, script generated |
| J12,J13 | Temp | Generic connector, single row, 01x03, script generated |
| J14,J15 | Battery & Fuse | Generic connector, single row, 01x04, script generated |
| J16,J17 | Power On/Off | Generic connector, single row, 01x02, script generated |
| J18 | Inverter remote | Generic connector, single row, 01x02, script generated |
| J19,J21 | Relays | Generic connector, single row, 01x04, script generated |
| J20,J23 | 12V Power | Generic connector, single row, 01x02, script generated |
| J22,J32 | Battery 2 | Generic connector, single row, 01x04, script generated |
| J24,J25,SW7 | Lights | Generic connector, single row, 01x02, script generated,Single Pole Single Throw (SPST) switch |
| J26,J27 | Duoetto Remote | Generic connector, single row, 01x02, script generated |
| J28 | Inverter Remote | Generic connector, single row, 01x02, script generated |
| J29,J33,SW10 | Solar Panel 1 | Generic connector, single row, 01x02, script generated,Single Pole Single Throw (SPST) switch |
| J31 | Solar Charge | Generic connector, single row, 01x02, script generated |
| K1,K2 | Relay 120A | Relay SPDT, monostable, EN50005 |
| K3,K4 | Relay 250A | Relay SPST, normally open, EN50005 |
| K5 | G5V-1 | Omron G5G relay, Miniature Single Pole, SPDT, 10A |
| K6 | Relay_SPDT | Relay SPDT, monostable, EN50005 |
| LA1 | Lamp | Lamp |
| M1 | Fan1 | Fan, tacho output, PWM input, 4-pin connector |
| M2 | Fan2 | Fan, tacho output, PWM input, 4-pin connector |
| R1 | 100 2W | Resistor |
| R2 | 1M | Resistor |
| R3,R4 | 47k | Resistor |
| R5,R7,R15,R16 | 680 | Resistor |
| R6,R46 | 2k2 | Resistor |
| R8-R10,R47 | 180 | Resistor |
| R11,R12 | 4k7 | Resistor |
| R13,R17,R50 | 150 | Resistor |
| R14 | 41R 2W | Resistor |
| R18,R20,R22 | 5k9 | Resistor |
| R19,R21,R23,R28,R41,R42,R49,R66 | 10k | Resistor |
| R24-R26,R29-R31 | 154k | Resistor |
| R27,R48,R65 | 68k | Resistor |
| R32-R34 | 22k | Resistor |
| R35-R37,R43-R45,R51-R64 | 1k2 | Resistor |
| R38-R40 | 100k | Resistor |
| Renogy 200Ah1,Renogy 200Ah2,Starter1 | Battery | Multiple-cell battery |
| SC1,SC2 | Solar_Cell | Single solar cell |
| SW1 | 12V Power On/Off | Single Pole Single Throw (SPST) switch |
| SW2 | Inverter | Single Pole Single Throw (SPST) switch |
| SW3 | Hot Water | Single Pole Single Throw (SPST) switch |
| SW4 | Air Suspension | Single Pole Single Throw (SPST) switch |
| SW5 | Pump | Single Pole Single Throw (SPST) switch |
| SW6 | Fridge | Single Pole Single Throw (SPST) switch |
| SW8,SW9 | Aux | Single Pole Single Throw (SPST) switch |
| SW12 | Solar Chg Battery 2 | Single Pole Single Throw (SPST) switch |
| SW13 | Battery 2 On/Off | Single Pole Single Throw (SPST) switch |
| SW14,SW15 | SW_Push | Push button switch, generic, two pins |