LightController_PCB
a6c0424fa083
This is the PCB (designed in KiCad) used in the LightController software
Components (23)
| Reference | Value | Description |
|---|---|---|
| Q2 | 2N7002 | 0.115A Id, 60V Vds, N-Channel MOSFET, SOT-23 |
| U1 | STM32F103C8T6 | STMicroelectronics Arm Cortex-M3 MCU, 64KB flash, 20KB RAM, 72 MHz, 2.0-3.6V, 37 GPIO, LQFP48 |
| U2 | SN75176BDR | A 2-way differenital - single ended converter |
| U3 | LM1117-3.3 | 1A Low Dropout regulator, positive, 3.3V fixed output, SOT-223 |
| C1-C5 | 100n | Unpolarized capacitor |
| C6,C12,C13 | 22u | Unpolarized capacitor |
| C7,C14 | 1u5 | Unpolarized capacitor |
| C8,C9 | 6p | Unpolarized capacitor |
| C10,C11 | 10u | Unpolarized capacitor |
| D1 | PWR | Light emitting diode |
| D2 | GP | Light emitting diode |
| J1 | USB_B_Micro | USB Micro Type B connector |
| J2 | USART | Generic connector, single row, 01x04, script generated |
| J3 | SWD | Generic connector, single row, 01x04, script generated |
| J4,TP2 | DMX | XLR Connector, Male or Female, 3 Pins,test point |
| R1,R2,R4,R6,R8 | 1k5 | Resistor |
| R3,R5 | 330R | Resistor |
| R7 | 150R | Resistor |
| SW1 | RST | Push button switch, generic, two pins |
| SW2 | BOOT0 | Switch, single pole double throw |
| TP1 | TX | test point |
| TP3 | INT | test point |
| Y1 | Crystal_16MHz | Four pin crystal, GND on pins 2 and 4 |