SMBR-hardware
TrendBit
Design file for SMBR hardware modules in KiCAD.
Components (45)
| Reference | Value | Description |
|---|---|---|
| Q501,Q502 | AO4435 | -10.5A Id, -30V Vds, P-Channel MOSFET, 13mOhm Ron, SO-8 |
| U401 | AT24C256 | 256 kb CMOS Serial EEPROM, DIP-8/SOIC-8/TSSOP-8/DFN-8 |
| U403 | REF3033 | 3.3V 50-ppm/°C Max, 50-μA, CMOS Voltage Reference, SOT-23-3 |
| U404 | RP2040 | |
| U405 | W25Q128JVS | 128Mbit / 16MiB Serial Flash Memory, Standard/Dual/Quad SPI, 2.7-3.6V, SOIC-8 |
| U501 | AMS1117-3.3 | 1A Low Dropout regulator, positive, 3.3V fixed output, SOT-223 |
| U601,U602 | SRV05-4 | ESD Protection Diodes with Low Clamping Voltage, SOT-23-6 |
| U701,U802-U804 | DRV8870DDA | Brushed DC Motor Driver, PWM Control, 45V, 3.6A, Dynamic current limiting, HTSOP-8 |
| U801 | SN65HVD230 | CAN Bus Transceivers, 3.3V, 1Mbps, Low-Power capabilities, SOIC-8 |
| U1202 | SN74LVC1G14DBV | Single Schmitt NOT Gate, Low-Voltage CMOS, SOT-23 |
| U1203 | SN74LVC1T45DBV | Single-Bit Dual-Supply Bus Transceiver With Configurable Voltage Translation and 3-State Outputs, SOT-23-6 |
| U1301 | ADS1115IDGS | Ultra-Small, Low-Power, I2C-Compatible, 860-SPS, 16-Bit ADCs With Internal Reference, Oscillator, and Programmable Comparator, VSSOP-10 |
| C401,C403-C405,C410-C415,C417,C419-C421,C501,C503,C505,C506,C702,C802,C804,C809,C814,C1201-C1204,C1301,C1603 | 100nF | Unpolarized capacitor |
| C402,C408,C409,C416,C418,C508,C509,C701,C703,C803,C805,C808,C810,C813,C815 | 1uF | Unpolarized capacitor |
| C406,C407 | 10pF | Unpolarized capacitor |
| C502,C504,C507,C510,C705,C807,C812,C817 | 10uF/25V | |
| C704,C801,C806,C811,C816 | 10nF | Unpolarized capacitor |
| D401-D403,D602 | RED | Light emitting diode |
| D404 | WS2812B | RGB LED with integrated controller |
| D405 | GREEN | Light emitting diode |
| D406-D409 | LED | Light emitting diode |
| D501,D504,D505 | SS34 | Schottky diode |
| D502 | MM5Z5V1 | Zener diode |
| D503 | SMBJ13CA | Bidirectional transient-voltage-suppression diode |
| D601 | B5817W | Schottky diode |
| D801 | PSM712-LF-T7 | Dual Line CAN Bus Protector, 24Vrwm |
| F501 | 2A | Fuse |
| FB401,FB501-FB503,FB601,FB701-FB705,FB801-FB807,FB901,FB1001,FB1101 | 120R@100MHz | Ferrite bead, small symbol |
| J1,J801 | SATA07-250B | |
| J501 | DC-044A-A200 | DC Barrel Jack with an internal switch and a mounting pin |
| J602 | U263-163N-4BLS1735 | USB 2.0-only 16P Type-C Receptacle connector |
| J701,J802-J804 | DF3A-03P-2DSA | Generic connector, single row, 01x03, script generated (kicad-library-utils/schlib/autogen/connector/) |
| R1-R4,R501 | 100k | Resistor |
| R401,R402,R602,R603,R1601 | 5.1k | |
| R403,R408,R410-R412,R423,R424,R604,R605 | 270R | |
| R404,R405,R413,R419,R701,R702,R803-R805,R807,R808,R810,R811,R1301,R1606,R1609 | 1k | |
| R407,R409,R420,R502,R503,R505,R1201 | 10k | |
| R414,R415,R417,R418,R421,R422 | 22R | |
| R601 | 0R | |
| R703,R806,R809,R812 | 100mR/0.5W | |
| SW401,SW402 | TS-1187A-B-A-B | |
| SW403 | DS-01R | 1x DIP Switch, Single Pole Single Throw (SPST) switch, small symbol |
| SW1201 | TC-6615-9.5-260G | Push button switch, generic, two pins |
| TH1601 | 10k, 3950b | Temperature dependent resistor, negative temperature coefficient |
| Y401 | 12MHz | Four pin crystal, GND on pins 2 and 4 |