nes_shell
TheBadZhang
NES 掌上游戏机，也不只是游戏机
Components (56)
| Reference | Value | Description |
|---|---|---|
| Q1 | SS9012 | PNP TO-92 low noise transistor, 20V, 500mA, 625mW, Complementary to SS9013, Alternate KiCAD Library |
| Q2 | PDTC114ET | NPN SOT-23 Pre-Biased transistor, 50V, 100mA, 250mW, Alternate KiCAD Library |
| U1 | STM32H7B0IBKxQ | STMicroelectronics Arm Cortex-M7 MCU, 128KB flash, 1184KB RAM, 280 MHz, 1.62-3.6V, 132 GPIO, UFBGA176 |
| U5 | M0S | |
| U6 | ADR421ARMZ | 2.50V Voltage Reference, Ultraprecision, Low Noise, MSOP-8 |
| U7 | AXP2101 | |
| U12 | REF3033 | 3.3V 50-ppm/°C Max, 50-μA, CMOS Voltage Reference, SOT-23-3 |
| U13 | CH334P | CH334 和CH335 是符合 USB2.0 协议规范的4 端口 USB HUB 控制器芯片，上行端口支持 USB2.0高速和全速，下行端口支持 USB2.0 高速480Mbps、全速 12Mbps 和低速1.5Mbps。不但支持低成本的的 STT 模式（单个TT分时调度4个下行端口），还支持高性能的 MTT 模式 （4个TT各对应1个端口，并发处理）。 |
| U15 | W25Q32JVZP | 32Mb Serial Flash Memory, Standard/Dual/Quad SPI, DFN-8 |
| U16 | MT48LC16M16A2TG | 256M – (16M x 16 bit) Synchronous DRAM (SDRAM), TSOP-II-54 |
| U17 | MPU-9250 | InvenSense 9-Axis Motion Sensor, Accelerometer, Gyroscope, Compass, I2C/SPI |
| U18 | CH343P | CH343是一个USB总线的转接芯片，实现USB转高速异步串口，同时支持115200bps及以下通讯波特率的自动识别和动态自适应，提供了常用的MODEM联络信号，用于为计算机扩展异步串口，或者将普通的串口设备或者MCU直接升级到USB总线。 |
| U19 | RT9193-33GB | |
| U20 | USB3300-EZK | Hi-Speed USB Host, Device or OTG PHY with ULPI Interface |
| BT1 | Battery_Cell | Single-cell battery |
| C1,C62,C81,C85,C94,C95 | 1uF | Polarized capacitor,Unpolarized capacitor,Unpolarized capacitor, small symbol |
| C2-C4,C87-C93 | 0.1u | Unpolarized capacitor |
| C5,C18 | 1.5pF | Unpolarized capacitor |
| C6,C7 | 8pF | Unpolarized capacitor |
| C8-C17,C19-C29,C50,C56,C82,C84,C97 | 0.1uF | Unpolarized capacitor,Unpolarized capacitor, small symbol |
| C30,C51 | C | Unpolarized capacitor |
| C31-C33 | 2.2u | Unpolarized capacitor |
| C52,C54,C86 | 10uF | Unpolarized capacitor,Unpolarized capacitor, small symbol |
| C53,C58-C60,C63-C65,C67-C70,C73-C78 | 2.2uF | Unpolarized capacitor |
| C55,C57,C61,C66,C71 | 22uF | Unpolarized capacitor |
| C72,C96,C99 | 4.7uF | Unpolarized capacitor |
| C79 | 100nF | Unpolarized capacitor |
| C80 | 0.47uF | Unpolarized capacitor |
| C83 | 220uF | Polarized capacitor |
| C98 | 22nF | |
| D1,D2 | LED | Light emitting diode |
| D3 | BAT54C | dual schottky barrier diode, common cathode |
| D4,D5 | ESD9B3.3ST5G | ESD protection diode, 3.3Vrwm, SOD-923 |
| F1 | Fuse | Fuse |
| FB1 | FerriteBead | Ferrite bead |
| H1-H4 | MountingHole | Mounting Hole without connection |
| J1,J2 | Conn_01x20_MountingPin | Generic connectable mounting pin connector, single row, 01x20, script generated (kicad-library-utils/schlib/autogen/connector/) |
| J3-J7 | Conn_02x06_Odd_Even | Generic connector, double row, 02x06, odd/even pin numbering scheme (row 1 odd numbers, row 2 even numbers), script generated (kicad-library-utils/schlib/autogen/connector/) |
| J10 | USB_C_Receptacle_USB2.0_16P | USB 2.0-only 16P Type-C Receptacle connector |
| L1-L5 | 1uH | Inductor |
| R1 | 10K | Resistor |
| R2-R5 | R | Resistor |
| R27 | 5.1k | Resistor |
| R28 | 10k | Resistor |
| R29,R30 | 5.1K | Resistor |
| R36-R41 | 33R | Resistor |
| R42 | 100K | Resistor |
| R43 | 4.7K | Resistor |
| SW3 | SW_Push | Push button switch, generic, two pins |
| TP5 | hub_ldo_3v3 | test point |
| TP6 | hub_gnd | test point |
| TP7 | DMU | test point |
| TP8 | DPU | test point |
| Y1 | Crystal_GND24 | Four pin crystal, GND on pins 2 and 4 |
| Y2 | Crystal | Two pin crystal |
| Y4 | 12M | Four pin crystal, GND on pins 2 and 4 |