cubesat
OSUSat
Open Source Earth Imaging Satellite Hardware + Firmware
Components (27)
| Reference | Value | Description |
|---|---|---|
| U1 | CM4 | Embedded single-board computer |
| U2,U5 | MCP2517FD-xJHA | External CAN FD Controller with SPI Interface, VDFN-14 |
| U4,U7 | SN65HVD230 | CAN Bus Transceivers, 3.3V, 1Mbps, Low-Power capabilities, SOIC-8 |
| U6 | 74LVC1G07 | Single Buffer Gate, Open Drain, Low-Voltage CMOS |
| U9 | DRV8846 | 1.4A stepper driver with microstepping |
| C1,C4,C9-C13,C15,C16 | 100n | capacitor, small US symbol |
| C2 | 10u | capacitor, small US symbol |
| C3 | 2.2u | capacitor, small US symbol |
| C5-C8 | 10p | capacitor, small US symbol |
| C14 | 1u | capacitor, small US symbol |
| D1,D2 | LED | Light emitting diode |
| D3-D6 | D_Zener | Zener diode |
| J2 | ARJM11C7-502-AB | RJ45 magjack, 10/100/1000 |
| J3 | USB_C_Receptacle_USB2.0_16P | USB 2.0-only 16P Type-C Receptacle connector |
| J4 | Conn_02x04_Odd_Even | Generic connector, double row, 02x04, odd/even pin numbering scheme (row 1 odd numbers, row 2 even numbers), script generated (kicad-library-utils/schlib/autogen/connector/) |
| J5 | Conn_01x05 | Generic connector, single row, 01x05, script generated (kicad-library-utils/schlib/autogen/connector/) |
| J10 | Conn_02x20_Odd_Even | Generic connector, double row, 02x20, odd/even pin numbering scheme (row 1 odd numbers, row 2 even numbers), script generated (kicad-library-utils/schlib/autogen/connector/) |
| JP1 | Jumper_2_Open | Jumper, 2-pole, open |
| R1,R2,R10,R11 | 1k | Resistor, small US symbol |
| R3,R4,R7 | 5.1k | Resistor, small US symbol |
| R5,R6 | 1 | Resistor, small US symbol |
| R8 | 12k | Resistor, small US symbol |
| R9 | 2k | Resistor, small US symbol |
| R12,R13 | 120 | Resistor, small US symbol |
| R17,R18 | 51k | Resistor, small US symbol |
| SW1 | SW_Push | Push button switch, generic, two pins |
| Y1,Y2 | 20 MHz | Four pin crystal, GND on pins 2 and 4 |