HaptiCAD
EmielV2002
A PC peripheral based on the smartknob project by scottbez1.
Components (36)
| Reference | Value | Description |
|---|---|---|
| U201 | SN74LV1T34DBV | Single Power Supply, Single Buffer GATE, CMOS Logic, Level Shifter, SOT-23-5 |
| U401 | VEML7700-TR | Optical Sensor Ambient 545nm I2C 4-SMD, J-Lead |
| U402,U403,U405 | TLV493D | Low power 3D magnetic sensor, I2C interface, SOT-23-6 |
| U404 | PCA9546A | 4-channel I2C-bus switch with reset |
| U501 | AP2112K-3.3 | 600mA low dropout linear regulator, with enable pin, 3.8V-6V input voltage range, 3.3V fixed positive output, SOT-23-5 |
| U601 | STSPIN233 | Low voltage three phase and three sense motor driver, 1.8V to 10V input, 1.3Arms output, 0.4Ω Rdson per phase (typical), QFN-16 package |
| U801 | STM32G431CBUx | STMicroelectronics Arm Cortex-M4 MCU, 128KB flash, 32KB RAM, 170 MHz, 1.71-3.6V, 42 GPIO, UFQFPN48 |
| C201-C217,C301,C401-C405,C801-C807 | 0.1uF | Unpolarized capacitor |
| C501,C502 | 10uF | Unpolarized capacitor |
| C601,C602 | 22uF | Unpolarized capacitor |
| C603,C604 | 2.2uF | Unpolarized capacitor |
| C605 | 1nF | Unpolarized capacitor |
| C606 | 10nF | Unpolarized capacitor |
| C808,C809 | 20pF | Unpolarized capacitor |
| D301 | PRTR5V0U2X | Ultra low capacitance double rail-to-rail ESD protection diode, SOT-143 |
| D501 | VPWR | Light emitting diode |
| D601 | FAULT | Light emitting diode |
| D801 | USER | Light emitting diode |
| J101 | BLDC | Generic connector, single row, 01x03, script generated |
| J102 | ENC | Generic connector, single row, 01x05, script generated |
| J103 | EXT_UART | Generic connector, single row, 01x04, script generated |
| J301 | USB_C_Receptacle_USB2.0_16P | USB 2.0-only 16P Type-C Receptacle connector |
| J801 | SWD | Generic connector, single row, 01x05, script generated |
| LED201-LED216 | WS2812_4020 | 4020 SMD adressable RGB LED with integrated controller |
| R301,R302,R501,R802 | 5.1k | Resistor |
| R401-R406,R408,R409 | 2.2k | Resistor |
| R601 | 3.3k | Resistor |
| R803,R804 | 27 | Resistor |
| SW801,SW802 | SW_Push | Push button switch, generic, two pins |
| TP201 | LED_DATA | test point |
| TP401 | SDA | test point |
| TP402 | SCL | test point |
| TP501 | GND | test point |
| TP502 | +5V | test point |
| TP503 | 3.3V | test point |
| Y801 | 12MHz | Four pin crystal, GND on pins 2 and 4 |