ShockSense
Consultant-47
Components (46)
| Reference | Value | Description |
|---|---|---|
| U2 | USBLC6-2SC6 | Very low capacitance ESD protection diode, 2 data-line, SOT-23-6 |
| U3 | MCP73833-xxx-UN | Stand-Alone Linear Li-Ion / Li-Polymer Charge Management Controller, MSOP-10 |
| U4 | MIC5317-3.3xM5 | 150mA Low-dropout Voltage Regulator, Vout 3.3V, Vin up to 6V, SOT23-5 |
| U5 | ADXL372xx | |
| U6 | LSM6DSV16BX | |
| U7 | BGM113A256V2 | |
| U8 | STM32L552VETxQ | STMicroelectronics Arm Cortex-M33 MCU, 512KB flash, 256KB RAM, 110 MHz, 1.71-3.6V, 79 GPIO, LQFP100 |
| C1-C5,C10,C16,C21-C27,C31,C34 | 100nF | Unpolarized capacitor |
| C6,C11-C13 | 4u7F | Unpolarized capacitor |
| C7,C33 | 10nF | Unpolarized capacitor |
| C8,C9,C14,C15,C28 | 1uF | Unpolarized capacitor |
| C17,C18 | 8pF | Unpolarized capacitor |
| C19,C20 | 15pF | Unpolarized capacitor |
| C29 | 10uF | Unpolarized capacitor |
| C30 | 47uF | Polarized capacitor |
| D1-D7 | LED | Light emitting diode |
| FB1 | FB | Ferrite bead, small symbol |
| J1 | USB_C_Receptacle_USB2.0_16P | USB 2.0-only 16P Type-C Receptacle connector |
| J2 | Battery Conn | Generic connector, single row, 01x02, script generated |
| J3 | SW Debug | Generic connector, single row, 01x05, script generated |
| J4 | SD Card Header | Generic connector, single row, 01x08, script generated |
| J5 | LSM2 | Generic connector, single row, 01x04, script generated |
| J6 | LSM1 | Generic connector, single row, 01x05, script generated |
| J7 | ADXL1 | Generic connector, single row, 01x04, script generated |
| J8 | CurrMeasure | Generic connector, single row, 01x03, script generated |
| J9 | ADXL2 | Generic connector, single row, 01x03, script generated |
| J10 | ADXL3 | Generic connector, single row, 01x02, script generated |
| J11 | BLE1 | Generic connector, single row, 01x03, script generated |
| J12 | Therm Conn | Generic connector, single row, 01x02, script generated |
| J13 | BLE2 | Generic connector, single row, 01x03, script generated |
| J15 | BLE3 | Generic connector, single row, 01x03, script generated |
| L1 | 4u7H | Inductor |
| M1,M2 | SiA811ADJxx | |
| R1 | 10k | Resistor |
| R2 | 8k | Resistor |
| R3 | 800R | Resistor |
| R4-R6,R15-R17,R20 | 221R | Resistor |
| R7,R8 | 5k1 | Resistor |
| R9-R14 | 47k | Resistor |
| R18 | approx 1k | Resistor |
| R19 | >33k | Resistor |
| SW1 | SW_SPDT | Switch, single pole double throw |
| SW2 | SW_Push | Push button switch, generic, two pins |
| TP1-TP7 | TestPoint | test point |
| Y1 | LSE 32.768kHz | Four pin crystal, GND on pins 2 and 3 |
| Y2 | HSE 32MHz | Four pin crystal, GND on pins 2 and 4 |