MyKiCad
CRImier
My KiCad boards. Can't be bothered uploading individually anymore, so here you go.
Components (75)
| Reference | Value | Description |
|---|---|---|
| IC1 | SN75LVDS83B | 5/0 Driver LVDS 56-BGA MICROSTAR JUNIOR (7.0x4.5) |
| Q1,Q2,Q5,Q7 | 2N7002 | 0.115A Id, 60V Vds, N-Channel MOSFET, SOT-23 |
| Q3,Q4 | Q_PMOS_GSD | P-MOSFET transistor, gate/source/drain |
| Q11 | SI4909 | |
| U1 | AP2112K-3.3 | 600mA low dropout linear regulator, with enable pin, 3.8V-6V input voltage range, 3.3V fixed positive output, SOT-23-5 |
| U2 | PAM2306AYPAA | |
| U3 | SL2.1A | |
| U4,U6 | RP2040 | A microcontroller by Raspberry Pi |
| U5,U7 | W25Q128JVS | 128Mb Serial Flash Memory, Standard/Dual/Quad SPI, SOIC-8 |
| U8 | FSUSB42MUX | |
| U9,U14,U15,U36 | SY6280 | |
| U10 | MIC2876 | 1.2 Mhz PWM Boost Regulator with Internal Schotty Diode, MLF-8 |
| U12,U13 | 74HC595 | 8-bit serial in/out Shift Register 3-State Outputs |
| U16 | RT6255 | 1.2 Mhz PWM Boost Regulator with Internal Schotty Diode, MLF-8 |
| U17 | PCF85363ATT | Tiny Real-Time Clock/calendar with 64 byte RAM, alarm function, battery switch-over, time stamp input, I2C bus, TSSOP-8 |
| U18,U19 | LM66200 | Ideal Diode, Ultra-Low Voltage Drop, 1.5-5.5V, 1A, SOT-23-5 |
| U20 | 24LC00 | I2C Serial EEPROM, 128 Bits, DIP-8/SOIC-8/TSSOP-8/DFN-8 |
| U21,U35 | ESD | Very low capacitance ESD protection diode, 2 data-line, SOT-23-6 |
| U22-U27,U31,U33,U34,U37,U39-U43 | TPD4E02B04DQA | 4-Channel ESD Protection Diode for USB Type-C and HDMI 2.0, USON-10 |
| U28 | BQ2501x | 500mA Li-Ion Charger w/Integrated 150mA Synchronous Buck Converter, QFN-14 |
| U29,U30 | 74LVC1G17 | Single Schmitt Buffer Gate, Low-Voltage CMOS |
| U32 | PCF8574ATS | 8 Bit Port/Expander to I2C Bus, SSOP-20 |
| BT1 | Battery | Multiple-cell battery |
| C1,C2 | 4.7uF | |
| C3,C4,C23,C29,C39,C45,C48,C49,C63,C75,C78-C80,C82-C86 | 1uF | Unpolarized capacitor |
| C5,C6 | 0.1uF | |
| C7,C8 | 0.01uF | |
| C9,C10,C50-C57,C61,C62,C88-C90,L1,L2,L5 | 4u7 | |
| C11,C12,C58 | 100p | |
| C13,C14 | 10u | |
| C15-C22,C24-C28,C30,C33-C38,C40-C44,C59,C60,C64-C67,C69-C74,C76,C91-C93 | 100nF | Unpolarized capacitor |
| C31,C32,C46,C47 | 15pF | Unpolarized capacitor |
| C68,C77,C87,C94-C98 | 22uF | Unpolarized capacitor |
| C81 | 47nF | Unpolarized capacitor |
| D1 | PMEG6010CEJ | Schottky diode, small symbol |
| D2 | SS34 | Schottky diode, small symbol |
| D3 | 5V1 | |
| D4 | LED_Small | Light emitting diode, small symbol |
| ISET1-ISET4 | x | |
| J1 | RPi_GPIO | |
| J2 | AXK750147G_VAIO-P | |
| J3 | AXK760347G_VAIO-P | |
| J4 | qwiic | |
| J5 | qwiic? | |
| J6 | 20374-R30E-31 | 30 POS Right Angle SMD 0.4 mm pitch vertical mating type micro-coaxial connector with friction lock CABLINE SS Receptacle |
| J7 | AXK740347G_VAIO-P | |
| J8 | RTC_BATT | Generic connectable mounting pin connector, single row, 01x02, script generated (kicad-library-utils/schlib/autogen/connector/) |
| J9,J10 | EXP | Generic connectable mounting pin connector, single row, 01x24, script generated (kicad-library-utils/schlib/autogen/connector/) |
| L3 | DR73-470-R 47uH | Inductor, small symbol |
| L4,L6 | 1u | |
| PD1-PD5,PD10 | 10K | |
| PD6 | RISET | |
| PD7-PD9 | RVSET | |
| R1,R2,R51,R54,R56 | 470K | Resistor |
| R3,R4,R9-R12,R17-R19,R34,R35,R42,R43,R50,R65 | 4.7K | Resistor |
| R5,R6,R53,R55,R57,R58 | 100K | Resistor |
| R7,R8,R13,R14,R32,R33,R40,R41,R60,R61 | 27 | Resistor |
| R15,R16,RN1,RN2 | 1.8K | 4 resistor network, parallel topology,Resistor |
| R20-R31,R62,R63 | R | Resistor |
| R36-R39 | Pu | Resistor |
| R44 | 5V_FB1 | |
| R45 | 5V_FB2 | |
| R46 | DC_FBU | |
| R47 | DC_FBD | |
| R48 | 5.1K | |
| R49 | 5K1 | |
| R52,R59 | 1K8 | |
| R66-R87 | 47R | |
| TP1-TP3 | TestPoint | test point |
| TP4 | D+ | test point |
| TP5 | D- | test point |
| TP6 | HDMI_POWER | test point |
| Y1 | 12MHz | |
| Y2,Y3 | ABM8-272-T3 | Four pin crystal, GND on pins 2 and 4 |
| Y4 | Crystal | Two pin crystal |