MyKiCad
CRImier
My KiCad boards. Can't be bothered uploading individually anymore, so here you go.
Components (54)
| Reference | Value | Description |
|---|---|---|
| Q1-Q3 | BSS138 | 0.115A Id, 60V Vds, N-Channel MOSFET, SOT-23 |
| U1,U5 | FSUSB42MUX | |
| U2 | W25Q128JVS | 128Mb Serial Flash Memory, Standard/Dual/Quad SPI, SOIC-8 |
| U3 | CH340C | USB serial converter, UART, SOIC-16 |
| U4 | TP4056 | |
| U6 | RP2040 | A microcontroller by Raspberry Pi |
| U7 | AP2112K-3.3 | 600mA low dropout linear regulator, with enable pin, 3.8V-6V input voltage range, 3.3V fixed positive output, SOT-23-5 |
| U8,U18,U19 | TPD4E02B04DQA | 4-Channel ESD Protection Diode for USB Type-C and HDMI 2.0, USON-10 |
| U10 | SL2.1A | |
| U11,U15-U17,U20 | SY6280 | |
| U12 | MCP23S17_ML | 16-bit I/O expander, SPI, interrupts, w pull-ups, QFN-28 |
| U13 | FUSB302BMPX | |
| U14 | ESP32-C6-WROOM-1 | ESP32-C6-WROOM-1/U is a module that supports 2.4 GHz Wi-Fi 6 (802.11 ax), Bluetooth® 5 (LE), Zigbee and Thread (802.15.4) |
| C1,C16,C23,C24,C32,C33,C37-C47 | 1uF | Unpolarized capacitor |
| C2 | 10uF | |
| C3,C4,C6,C7,C9,C10,C12-C15,C17-C22,C29-C31,C34,C48 | 100nF | Unpolarized capacitor |
| C27,C28 | 15pF | Unpolarized capacitor |
| C35,C36 | 100p | |
| D1-D3 | LED 0603 | |
| D4 | SS34 | |
| F1 | 2A PTC | |
| J1,J2,J14-J16 | SH 4P | |
| J3 | Raspberry_Pi_2_3 | |
| J4 | USB | Generic connector, single row, 01x03, script generated (kicad-library-utils/schlib/autogen/connector/) |
| J5,J8,J18 | USB_C_Receptacle_USB2.0_16P | USB 2.0-only 16P Type-C Receptacle connector |
| J6 | USB_C_Host_a | USB 2.0-only 16P Type-C Receptacle connector |
| J7 | Bus_PCI_Express_Mini | Mini-PCI Express bus connector |
| J9 | l | Generic connector, single row, 01x10, script generated (kicad-library-utils/schlib/autogen/connector/) |
| J10 | b | Generic connector, single row, 01x08, script generated (kicad-library-utils/schlib/autogen/connector/) |
| J11 | r | Generic connector, single row, 01x10, script generated (kicad-library-utils/schlib/autogen/connector/) |
| J12 | Sn | Generic connector, single row, 01x04, script generated (kicad-library-utils/schlib/autogen/connector/) |
| J13 | KP | Generic connector, single row, 01x08, script generated (kicad-library-utils/schlib/autogen/connector/) |
| J17 | FPC 24P 0.5mm | Generic connectable mounting pin connector, single row, 01x24, script generated (kicad-library-utils/schlib/autogen/connector/) |
| J19 | SIM_Card | |
| J20 | Conn_01x01 | Generic connector, single row, 01x01, script generated (kicad-library-utils/schlib/autogen/connector/) |
| J21 | Conn_01x04 | Generic connector, single row, 01x04, script generated (kicad-library-utils/schlib/autogen/connector/) |
| J22 | Battery | |
| N1,N2 | SK6805 | |
| R1,R2,R8,R22,R23,R31,R35,R38,R49,R50,R65,R67 | 5.1K | Resistor |
| R3,R41,R42 | 56K | Resistor |
| R4,R7,R9,R12-R15,R20,R28,R53 | 1.8K | Resistor |
| R5,R6,R34 | 100K | Resistor |
| R10,R11,R36,R37 | 27 | Resistor |
| R16-R18,R43-R48 | 47R | Resistor |
| R19,R24,R27 | NP | |
| R21,R25,R26,R30,R39,R40,R59,R60 | 0R | |
| R29,R61,R62 | NC | |
| R32,R63 | 12K | |
| R33,R52,R56,R58,R64 | 20K | |
| R51,R55,R57 | 12k | |
| SW1 | bootton | Single Pole Single Throw (SPST) switch |
| SW2 | resetton | Single Pole Single Throw (SPST) switch |
| TP4-TP6 | TestPoint | test point |
| Y1,Y2 | 12MHz | Four pin crystal, GND on pins 2 and 4 |