FalCAN
AndersBNielsen
The FalCAN Probe does USB to CAN, RS-485 and full duplex RS-422
Components (28)
| Reference | Value | Description |
|---|---|---|
| U1 | STM32F042C6Tx | STMicroelectronics Arm Cortex-M0 MCU, 32KB flash, 6KB RAM, 48 MHz, 2.0-3.6V, 38 GPIO, LQFP48 |
| U2 | SN65HVD230 | CAN Bus Transceivers, 3.3V, 1Mbps, Low-Power capabilities, SOIC-8 |
| U3,U4 | SP3485EN | Industrial 3.3V Low Power Half-Duplex RS-485 Transceiver 10Mbps, SOIC-8 |
| U5 | MIC5504-3.3YM5 | |
| C1,C8-C14 | 100nF | Unpolarized capacitor, small symbol |
| C2-C4,C7 | 15pF | Unpolarized capacitor, small symbol |
| C5,C6 | 1uF | |
| D1 | GREEN | Light emitting diode |
| D2 | RED | Light emitting diode |
| FB1 | FerriteBead_Small | Ferrite bead, small symbol |
| J1,J3 | Conn_01x17_Pin | Generic connector, single row, 01x17, script generated |
| J2,J6 | NC | Generic connector, single row, 01x02, script generated (kicad-library-utils/schlib/autogen/connector/),Generic connector, single row, 01x04, script generated (kicad-library-utils/schlib/autogen/connector/) |
| J4 | USB2.0_16P | USB 2.0-only 16P Type-C Receptacle connector |
| J5 | Boot | Generic connector, double row, 02x03, odd/even pin numbering scheme (row 1 odd numbers, row 2 even numbers), script generated (kicad-library-utils/schlib/autogen/connector/) |
| J7 | DE9_Receptacle | 9-pin female receptacle socket D-SUB connector, Mounting Hole |
| J8 | RS-485/422-TX | Generic connector, single row, 01x03, script generated |
| J9 | RS-422-RX | Generic connector, single row, 01x03, script generated |
| J10 | CAN | Generic connector, single row, 01x03, script generated |
| JP3,JP4 | RS-422 | Jumper, 2-pole, open |
| R1,R2,R4-R9 | 10k | Resistor |
| R3 | 1k5 | Resistor, small symbol |
| R10-R12 | Rt | Resistor, small symbol |
| R13-R15,R19 | 5k1 | Resistor, small symbol |
| R16,R18 | 100k | Resistor, small symbol |
| SW3 | BTN | |
| TP1 | VCC/2 | test point |
| Y1 | 8MHz | Four pin crystal, GND on pins 2 and 4, small symbol |
| Y2 | 32768Hz | Two pin crystal, small symbol |